Jump to content
SAU Community

Recommended Posts

If you need something for your R34 that you can see in the pics let me know on 0402 902 759

R34 Neo Engine 104,000kms (Engines now out and ready to be collected)

Including basically everything you need to run it, minus turbo.

$1,900

Drivers and Passengers Seat - $300 for the pair or $170 each

Very light wear on the drivers seat as you can see in the pics, passengers has no wear

seats2y.jpg

seats1u.jpg

seats3.jpg

Rear Seat - $80

No marks, great condition

rearseat.jpg

Speedo - $50

104,000kms

speedoe.jpg

Factory R34 GT-T Floor Mats - $80

floormats.jpg

If you see a car part you need in the pic let me know. Shell is leaving on Monday!

Also have boot lining in great condition with all clips

insidefront.jpg

engineaa.jpg

  • 2 weeks later...

Is the front drivers seat still available? I'm chasing one down.

Do you know if the seat mounts between coupe/sedan are the same? Nobody seems to be able to tell me ..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...