Jump to content
SAU Community

Recommended Posts

Hey guys

Ive got some pretty bad paint missing on my car.

Reason for it is from my own stupidity.

I tried to remove vinyl's from my car ( i researched it and how to do it but still failed )

The main source of the problems are the side skirts, with paint "flakes" removed upto 10-15 cm by 3cm on each side.

The other main source is near the Fuel opening, which has a 20cm by about 3 cm paint removed, ( completely flaked off).

Now im not sure if this car has been resprayed before so i dont know if its original paint ( hoping it is original )

I have found a couple of placed in perth that do this stuff, but i dont know if they are good for skylines, or the price range for this or if they even do this type of fix.

http://www.dreamworkspanelandpaint.com.au/car_services.shtml

http://www.touchupguys.com.au/perth/eastern.php

What do you guys think?

And anyone else had a similar paint touch up done?

Link to comment
https://www.sau.com.au/forums/topic/367579-paint-repair/
Share on other sites

Hey guys

Ive got some pretty bad paint missing on my car.

Reason for it is from my own stupidity.

I tried to remove vinyl's from my car ( i researched it and how to do it but still failed )

The main source of the problems are the side skirts, with paint "flakes" removed upto 10-15 cm by 3cm on each side.

The other main source is near the Fuel opening, which has a 20cm by about 3 cm paint removed, ( completely flaked off).

Now im not sure if this car has been resprayed before so i dont know if its original paint ( hoping it is original )

I have found a couple of placed in perth that do this stuff, but i dont know if they are good for skylines, or the price range for this or if they even do this type of fix.

http://www.dreamwork..._services.shtml

http://www.touchupgu...rth/eastern.php

What do you guys think?

And anyone else had a similar paint touch up done?

Dreamworks are good, I've seen some of their work before. Price will depend on the damage and what type of paint it is (ie, metallic, gloss, etc). Without looking at it, it's hard to say. Could be anywhere from $200 to over a grand. From your description, it sounds like they will have to completely respray your side skirts. You're probably looking at about $300-$400 for that if they do the prep work. The damage near the fuel cap sounds more serious. To do a good job, they would have to completely respray the panel and then blend into the panels next to it. I'd say you're looking at upwards of $500 for that. But best to take it for a quote and see what they have to say.

As for whether it is the original paint or not, look up the paint code in the engine bay and then go here to confirm the colour: http://www.skylinesaustralia.com/forums/topic/138419-nissan-paint-codes/

If it's not a match then it isn't a big deal, paint shops have a device that they put on your paint to tell them what's in it so they can determine the colour. So it won't be a problem either way.

Link to comment
https://www.sau.com.au/forums/topic/367579-paint-repair/#findComment-5863142
Share on other sites

Thanks for that. :)

Its a toss up on, new exhaust or Re paint hmmmm.

Like you said got get a qoute to see what they think.

I should of gotten a professional to do the vinyl removal but i was like " how hard could it be"

Stupid me.......I suppose it could of been alot worse...as the vinyl was on the entire side of the car lol.

The Paint looks metallic, i will check the codes after work.

Link to comment
https://www.sau.com.au/forums/topic/367579-paint-repair/#findComment-5863164
Share on other sites

Thanks for that. :)

Its a toss up on, new exhaust or Re paint hmmmm.

Like you said got get a qoute to see what they think.

I should of gotten a professional to do the vinyl removal but i was like " how hard could it be"

Stupid me.......I suppose it could of been alot worse...as the vinyl was on the entire side of the car lol.

The Paint looks metallic, i will check the codes after work.

If it's metallic, I daresay it will be more expensive. It's a real bitch to spray.

You could always just learn how to spray paint yourself... It's not hard :P

Link to comment
https://www.sau.com.au/forums/topic/367579-paint-repair/#findComment-5863167
Share on other sites

Well i have a air compressor and a spray gun attachment.

My brother used it to Respray his entire car.

I suppose i could do it.

How much would paint be for it?

If you've got the equipment, definitely give it a go. It's all in the prepwork. Hardest part is getting the right mixture of paint vs thinners.

Paint cost again depends on the paint. I got 5L of QM1 cloud white mixed for my car for $160. Then clear coat was about $80 for 2L, but it needs to be thinned out so much that I only used about 1L. If you have metallic paint, it will be more expensive. And harder to spray, though still give it a shot. Just practice on something first :P

*EDIT* The effected areas do look a bit challenging. If you have metallic paint, it will be very hard to blend that damage near the fuel lid. Is the damage on the bottom actually on the skirts or just above them?

Edited by Hanaldo
Link to comment
https://www.sau.com.au/forums/topic/367579-paint-repair/#findComment-5863203
Share on other sites

Edit: Its on the Skirts, though there is 1 bit of paint damage on the actual door ( that was there before the vinyl removal ).

Yeh, ill see if i have any friends that have done it before and get them to help out.

~ 250-300 dollars is alot better than 1 grand lol :P

I will still get a qoute actually, just to see the price, if its around the 1k mark ill have a crack at doing it myself.

Edited by jay-rod
Link to comment
https://www.sau.com.au/forums/topic/367579-paint-repair/#findComment-5863208
Share on other sites

I can definitely recommend Topgun Touchups 0433 837 839

I got him to do some temporary touchups thinking I'd respray the bumpers later.

He did such a good job there was no need

My GTR is silver too

Edited by R34
Link to comment
https://www.sau.com.au/forums/topic/367579-paint-repair/#findComment-5866289
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...