Jump to content
SAU Community

Recommended Posts

Hi Guys

yesterday i was driving to my mates ( a good hour of driving to his place) when i got into town my car just shut off and i had to roll it to the side of the road. Once i was on the side of the road i tried to start and it wouldnt go, sounded like the battory was dying so anyway I checked under the engine, was warm but still had coolant in the tank thing and had enough oil so i didnt really think anything of it, i ended up leaving it for 5 and it started thought ill just take it to my mates place and drive like a grandma. so i took it to his place and it stopped just on the corner from his place. so i got my mate and a few other guys that were around to push it to his place. We had a bit of a look and let it cool down.

When we looked after it cooled down abit, we noticed that there was only air in the radiator (Which i know is definatly a bit thing) we got the hose and tried to fill the radiator and were going to see what happened from there. then we noticed the water was just coming straight back out. There was a mechanic there at the time and he said its a stuffed water pump and i will need a new one.

Basically I know something will be damaged probably the head or something, What I want to know is what do you guys reckon will be damaged and also what are some ways I can check/test or even signs to look out for while im driving it.

Oh and the temp gauge had been playing up so I didnt really notice it heat up. And Yes I had been checking Oil and water regularly - Thought the coolant was fine as it hadnt moved in that tank on the side so i wouldnt have noticed. and Iv never seen anything leaking/any wet patches under it.

Thanks Heaps

Dan

Link to comment
https://www.sau.com.au/forums/topic/372650-r33-skyline-stuffed-water-pump/
Share on other sites

get a compression test and other tests done to determine if youve killed the motor, these will reveal if youve done the HG or cooked (lose the tension) the rings, if thats all good then just change your water pump and put a timing belt kit in it if its due(while things are apart)an oil + filter change might be needed as the oil wouldve got very hot and fix the guage

Edited by StevenCJR31

had exactly this a while back but noticed it as soon as the temp began going above normal and as i pulled to the side of the road the steam which had been unnotcable driving at speed was apparent as it was coming from the sides of the bonnet. Stopped it and had it towed to the shop n put it in for a full 100k km service (timing belt, water pump, seals etc etc). All good thankfully. No damage done whatsoever.<BR><BR>U've got the prob of ur thermostat playing up so you dont know how hot it really got.<BR>Doesnt sound good tho if the car conked out on you...<BR>fingers crossed that ur as lucky as me though.<BR><BR>Good word of advice though, check your dates on the last 100k service (find a import specialist shop who can read the Jap dates if its pre-import). If it is impossible to tell when it was done or if it was done more than 5-7 years ago n before importing then get it done. Not worth the risk of the water pump or timing belt letting go n killing your engine... <BR><BR>my 100k service was 'only 50k kms ago' (importing may have changed that figure tho) but 8 years ago. Ad to that the muck that can accumulate in the cooling system during the import process and the expected life may not be 10 years (which is the maximum that the 100k service parts are rated too)

Edited by jjman

When there is a leak in the cooling system there is no pressure or vacuum so the little tank doesnt go up or down, also when there is no water in the engines cooling system the gauge will basically read cold as there is no hot water on the sensor.

Hopefully when u fix it will be ok otherwise it may need head service and gasket kit. Hard to tell over the net.

Try and fill it up and get it running to see how it runs. Its a big job to replace the water pump and it woukd be disappointing to replace the pump and get it running only to find u have to pull the head back off

I left it at my mates place in Ulverstone and i got a mechanic over there to work on it for me as I live and work in Burnie.

I'v got a new thermostat and the water pump should get here today so hopefully I haven't done any other damage.

I'll let you guys know how I go.

Thanks for the advice!

mine was doing the same thing and was pissing out of the 'inspection hole' (i think that is what the mechanic called it) on the front of the water pump.

Tell-tale hole ;)

was coming out of the front part of the engine at the bottom and the mechanic that was around said it was a water pump. why's that?

You never specified where it was leaking from, I wasnt sure if you knew it was coming from around the water pump or it was coming from somwerher else. You might be able to see if it is indeed coming out of the pump if you take the timing cover off. Might (not 100% sure) be able to look down through there and see.

It will at least let you know if it is def the water pump leaking. but sounds like it probably will be the issue

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...