Jump to content
SAU Community

Recommended Posts

Mesh. 1stly, WICKED :D

What are the prices mate?

The design looks great, just take out the AutoSalon

They aint paying us to promote them, they have thier own money for that.

We had 2000 thou last year, and they didnt last long at all.

So 4000-5000 is the number we require, but that comes back to cost.

If you wanna discuss further - 0408 33 77 07 just ring me.

Easier than a forum

  • Replies 94
  • Created
  • Last Reply

Top Posters In This Topic

we should see next time if we can get cheap tickets in bulk... seeing as most of us are going there... and maybe even some freebies for advertising on flyers and our shirts :D

Those flyers look awesome....

but theres a punctuation issue,

skyline's should be skylines

not skyline's

The word is used as a plural noun, so there shouldn't be an apostrophe.

:thumbsup:

Maybe get rid of the 2004 bit as well, that way if there are any left over, they can be used again next year.

I missed this thread. :D

I have been too busy anyway to help out, and I apologise for this as I see the effort made by you guys and I have been struggling to get my car ready. If my employer had not taken the weak option to attend the semi-final later this year without my knowlege things would have run alot smoother, and i would have had the excuse to be more involved if there was a company focus to represent. Not to mention i would have had a relliable lift to and from the event that has evaporated before my eyes!!

Anyway I just wanted to thank you all for your efforts and look forward to a massive weekend!!! :thumbsup::D:D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...