Jump to content
SAU Community

Recommended Posts

Chris would proberbly know. From what I've seen playing with mine is they are powered so I jumper or something is needed on the non option deck to power it. Also haven't seen back of a non Bose radio so don't know if they got the space for the plug.

also, no, there is no wiring to the sub for the non-bose cars. but there is an amp built into the sub enclosure, so it wouldnt be difficult to work out the power wires and the audio input

no mate i dont, im lacking the mounting screw for the sub to hold it and the spare wheel into the wheel well.

if i did, id have it hooked up already! i THINK it uses a speaker level input from the amps that are usually in the boot of the bose equipped models.

from an aftermarket head unit, i wouldnt imagine it would be too hard to wire up.

for $80 its worth taking the risk! lol

  • 2 weeks later...

as a FYI. these need at least a 6Vpp balanced signal into them to run properly.

if its still available can you take a measurement from the base to the top of it. I want to see if I can get it in the spare tyre well of my R32.

Hi there, I am in Adelaide & also interested. I have sent you a PM.

you would be better off with the 6x9s that go in the rear shelf of yours..

you would be better off with the 6x9s that go in the rear shelf of yours..

Would you have any recommendations? While you are at it what about the fronts also? I know that it is subject to personal taste & budget but maybe a rough guide would interest a few people.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...