Jump to content
SAU Community

Recommended Posts

Just got my car road tuned before the dyno with 740cc deatchwerks, in hind sight they might have been too big for my application (rb25 neo with 250kw highflow)

I went from a crappy magnaflow reg with 440cs to a stock rail, reg with the 740s and the car started stone cold first go, ironically it idled and low load was actually better with it untuned than it ever used to be, starts every time with no throttle.

Anyway got Pete at Nistune to do a road tune with them to make sure there weren't any major issues before the dyno, unfortunately due to their size we had to play with the k factor a fair bit to get enough resolution to get the AFRs above 10:1 in the top end, this in turn meant my idle and low load suffered a bit, though with lots of tweaking the latency and making sure the O2 was set up correctly got it as good as it was before, able to mantain stoich idle and get it up to 11.5:1 in the top end with enough resolution to still tweak it further.

The real test will be when we get it properly tuned on the dyno and see what sort of economy I get, it is fairly poor at the moment but the tune was just a "good enough" one before getting on the dyno.

Pete was very sceptical of them being able to work with the nistune and get the low load/idle/cold start working properly but when he saw how well they worked was quite surprised, even more so that they worked with no tweaking at all from my previous setup. Will report back when I get the full tune done and do some testing to see what fuel economy is like.

Edited by Rolls
  • 4 weeks later...
  • Replies 94
  • Created
  • Last Reply

Top Posters In This Topic

Getting ~14-15L/100km city driving with a good enough tune, better than with GTR injectors as I was getting closer to 16 and the same driving style

gets properly tuned tonight, will see if it improves.

Edited by Rolls

I only have 555cc nismo injectors, but I get like 9L /100km according to my ecutalk consult display and nistuned z32 ecu.

I was always under the impression if you get a full tune (not just 4th gear power runs) then you should get reasonable economy regardless of injector size. Obviously the bigger the injector the harder it will be to have good economy on light loads though.

Have I been under the wrong impression?

Depends on the injectors minimum pulse width. My min pulse width is smaller with DW 600cc than the stock inj minimum, so it negates any idea that they won't cruise or idle on stoich. Don't know about the 1000/2000s.

Also, I don't know how your cars tuned Mitch, but I've found that the trip computer economy goes out the window if you change injectors because you also change the K constant. E.g, my car now thinks I can do 1000kms on a tank because My k constant almost halved within the factory ECU. Its obviously not going to do 1000km on a tank any time soon!

Depends on the injectors minimum pulse width. My min pulse width is smaller with DW 600cc than the stock inj minimum, so it negates any idea that they won't cruise or idle on stoich. Don't know about the 1000/2000s.

Also, I don't know how your cars tuned Mitch, but I've found that the trip computer economy goes out the window if you change injectors because you also change the K constant. E.g, my car now thinks I can do 1000kms on a tank because My k constant almost halved within the factory ECU. Its obviously not going to do 1000km on a tank any time soon!

I was just quoting what my ecu consult display says. I think it should be reasonably accurate though, because my nistuned z32 ecu still supports consult and the nistune daughterboard adjusts all the values to suit everything before being read at the consult port.

But it could be wrong as well. Pre tune on stock setup I was getting about 450km per tank running it down to just before the fuel light.

So far I have done 300km and still have a bit less than half a tank.

I was just quoting what my ecu consult display says. I think it should be reasonably accurate though, because my nistuned z32 ecu still supports consult and the nistune daughterboard adjusts all the values to suit everything before being read at the consult port.

But it could be wrong as well. Pre tune on stock setup I was getting about 450km per tank running it down to just before the fuel light.

So far I have done 300km and still have a bit less than half a tank.

Lol are you ever on boost?

I was just quoting what my ecu consult display says. I think it should be reasonably accurate though, because my nistuned z32 ecu still supports consult and the nistune daughterboard adjusts all the values to suit everything before being read at the consult port.

But it could be wrong as well. Pre tune on stock setup I was getting about 450km per tank running it down to just before the fuel light.

So far I have done 300km and still have a bit less than half a tank.

It doesn't adjust the fuel figures, ignore them and work it out properly, there is not way you get 9L/100km

do it the way everyone else does, run to empty, full tank, reset odo, run to empty, divide litres used / odo * 100

Edited by Rolls

Lol, you wish sunshine, unless youre on the highway the whole time or you don't boost, ever!

I'm not gonna argue with people about it, because it's so trivial. I'm open to the fact the ecutalk consult might not be right with econom calculations now, but I know how far I travel on each tank and how much fuel the car takes when I go to fill it up. Canberra doesn't have crazy traffic though, its pretty open, so that could be part of it.

Edited by Mitcho_7

You may get a reading of 9L per 100km at one particular point in time but that is not the same as an actual average consumption figure. Km per tank are not accurate you need to measure the fuel used for a given number of km and do the calculation.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey crew, Failed my WOF cause of a lower control arm, and I've decided to hit both arms, and also the compression rods at the same time(seems they're gonna be the most likely upcoming failure points from some discussions with the lads over on the G35 reddit). I've looking at these form Z1:  https://www.z1motorsports.com/front-suspension/hayaku-automotive/hayaku-g35-front-compression-rod-p-40716.html https://www.z1motorsports.com/front-suspension/hayaku-automotive/hayaku-g35-front-lower-control-arm-p-40674.html I asked Z1 if they'd work as it's the same platform, just RHD vs LHD. I basically got told "Lol dunno". Specifically they aren't aware of any difference but can't guarantee fitment as they haven't done it on a 350GT. So guess I'm asking is if there is any issues with using 2005 G35 coupe suspension parts on a 2005 350GT coupe? Orginally I thought it could be something in the way of the arms that each control arm is designed to be positioned around, but that'd be an engineering nightmare for Nissan needing two different shaped control arms 😅
    • ^ This. The mode door actuator is a common failure, as is the actuator and/or the actual valve for the coolant flow control valve. I also don't know how available the mode door actuator is these days. I've been meaning to look into it and get one from wherever is possible, to keep in the shed for the rainy day when mine eventually fails. Anyway, the advice to you is to search the usual NOS part supply places, or even just go to Nissan and see what they list.
    • Have you got a pic of the actuator? My guess is that unit has failed internally and was flopping around, so the previous engineer who owned it forced it to be fully open to cold air (blocking the heater core path). As far as you can tell, is anything else wrong in the system? Likely you just need a new actuator (not sure how available they are) and then "installation is the reverse of disassembly"
    • I'm happy with the Lsailt unit that I put in, it puts full Android on the top screen so you can run whatever Nav and other Apps you want, while still existing inside the factory functionality like automatic reverse cams, audio input switching, retains factory bluetooth etc. Not cheap and the install was moderate (not simple, not hard) Yours is a V36 not V37 though right?
    • Yeap, all the NC's that I originally looked at that had a hard top were PRHT, which makes the roof line look horrible, hence why I said nope to them My only caveat for another MX5 was it needed to have a hard top, and initially I didn't think you could get a detachable hard top for the NC,  like my NB had Again, a big thanks to Matty for helping me source the detachable hard top for my little girl, they are as rare as hens teeth in Australia, and the few people who have them, keep them Also to Greg, for initially pointing me in the NC direction NC PRHT 🤢🤮 Not mine (I really should take more photos of my car), but a NC with the detachable hard top 😁 To me, the difference in how the detachable hard top roof line looks, and how it actually follows the bodies lines, like they do on NA's and NB's, is chalk and cheese compared to the bulbous looking PRHT  
×
×
  • Create New...