Jump to content
SAU Community

Recommended Posts

Looking at selling works off my 33. Previous owner had them refurb'd not long before i bought the car. So in pretty decent condition not 100% sure on ofset. Believe fronts which are 18x9's are around the +25 mark and rears which are 18x10's are around the +30. Could be wrong will have to check but. Both front and rear sit flush with guards. And both front and tears have had fresh federal 595s fitted in past fortnight.

Can contact me on 0420986545.

Open to offers. Haven't got a set price as yet. Using my phone atm and cant upload pictures atm. Can mms pictures of wheels. Txt the above number if you want pic's

$200....this is not ebay...post an asking price as per forum rules.

width and offsets are stamped behind the wheel. Post them up if you want to sell them quicker.

Edited by n15m0

$352 With over night courier to Brisvegas? I want a brand new set of nismo wheel nutz thrown in on the deal as well plz.

I get paid at the end of November so send em ova and i fix u up in 8 months?

As it says up top its 'eoi'. Offset is...fronts +30 (running 5mm slip ons) and rears are +25. Feel free to make reasonable offers rather than clogging up the post with shit!

$354

And read the for sale rules- no EOI's- you need a price or this will get closed by Admin. Thats why people are dicking around.

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Sorry I didn’t explain myself properly, by free revving I meant if I just floor it, it gets to 7kish and will start to break up/not hit limiter properly, off boost I’ve driven the car until near on empty. I have a fuel pressure gauge mounted in the engine bay, holds fuel pressure consistently full tank or half tank even when revving, and no the pump sound doesn't change. all the fuel lines inside the tank are fairly new but will look into it, could that also be an issue with the lines outside the tank ?
    • Yeah maybe I got a bad batch that only lasted 6 years. Or conversely maybe I got a good batch that managed to last 6 years.    Either way I have sourced a set of OEM hub/bearing assemblies  so I keep hearing! Even from life long mechanics. Apparently this failure is unheard of…
    • I am trying to understand how that even happened to the hub... wtf
    • Hell, I'm sufficiently wary of the ZSS suspension arms, let alone something like a hub.
    • Got it back home and got started pulling the hub off and diagnose the issue. Axle was stuck after removing the 36mm nut so i used a 3 jaw puller to try and push it out and... eH5FXvJ8.mp4   spend the next few hours trying to remove the axle from the remaining hub as it was very much jammed in there when the spindle sheared off. resulting damage as below R53AIy6 - Imgur.mp4   Looks like the was already a stress fracturing in the spindle as can be seen with the darker cracked section My working theory is maybe when the pinion gear exploded last year the shock put through the hub was the initial crack. Then a few events later it finally let go. Just lucky it happened where it did and not 190km/h on the next sweeper or into the hairpin The bearing/hub assembly went in in 2019 and were non-genuine "ZSS" assemblies and no nails were harmed in the process. #BreakHubsNotNails
×
×
  • Create New...