Jump to content
SAU Community

Recommended Posts

Jumped in my car this morning and it was making a weird high pitch buzzing/squeaking noise. It SOUNDS like a belt rubbing against something but I could not see anything. My dad says it may be a problem with a bearing, but I do not know what that means, as I am by no means a mechanic.

Took a short video from inside the car which is where I first heard it, then down to the left of the air intake near the fan where it seemed to be the loudest. My car is a r34 gtt, so a rb25det neo. The car is basically stock, bov, catback exhaust, hks mushroom air filter, bleeder valve + tune. Engine doesn't seem to be unresponsive or having any problems but I was too afraid to give it too much piss just incase something did happen. It is due for a service within a month, (every 5000kms, last service was a 100,000km) only done 102k kms. Anyone have any ideas?

Edited by voncina
Link to comment
https://www.sau.com.au/forums/topic/396487-engine-making-weird-noise/
Share on other sites

take all the ancillary belts off one by one (remember that the one that goes on your fan also runs the water pump so dont run it for a long time with that off) and see if the noise goes away

It may be the idler pulley bearing for the A/C

Otherwise it may be underneath the timing cover, as said above, something may not have been done right in the 100,000km service or it may not have been done at all

Also have a feel of your crank angle sensor (on the front of the timing cover) just in case the bearing in there has gone. Mine used to make noises before I put my new CAS on, but they were different noises to that. Cant rule it out but

Edited by 89CAL

New belts will generally stretch after a a while. It even says to readjust them after installing.

Just watched the video. Did you have your A/C on while you were taking the vid? Cause my compressor sounds like that when engaged, just not as loud.

  • 1 month later...

Did you find out what the noise is?

Mine started the same noise from what looks the same place.

Will be taking belts off one by one this weekend.

Mine dont start making the sound until about 5-10 seconds after start up, then slowwwwly gets quieter and quieter. Similar?

Noise hasn't gone away, but is loudest and only really noticeable early morning when it is cold. I am pretty sure it is one of my belts because when the turbo timer is running and I hop out of the car there is another sound that actually sounds like a belt. When I get my next service I will just get the belts looked at, if something happens earlier I will blame my mechanic - I take it to a mechanic because I am not a mechanic. I pay him enough, my car should run perfect all the time. If it doesn't, I am going to rain shit on him.

Hey mate, no luck. I couldn't be f'd taking off all the belts, the power steering belt felt a bit loose so I gave it a tweak but nothing. I am pretty sure its coming from the timing train somewhere. Belt rub, pully or bearing. I have just had my timing belt done but like... 500km ago and its been quiet up till I take off the exhaust manifold . Makes me think its something I have done, but ummmm... Didn't work near that area. :huh:

Ive booked my car Wednesday to get it checked out. Just had a new engine dumped in so these sorta things have me on my toes. Ill let you know what he comes up with.

I am sure you have the same prob as mine, when car is cold its LOUD. Sound starts about 5 secs after running, slowly goes away after a few mins, will come back with minor revs till that slowley goes away and then only does it at high rpm.

See if there is somewhere (safe) on each of the items with a pulley (a/c, power steering etc.) and place the end of a very long screwdriver directly onto the casing of the metal as close as you can to the pulley and the other end to your ear while the engine is running, This will tell you straight away exactly which device/pulley is causing the noise, trust me you will know it when you hear it using this method. Then again on my commodore the thermo fan was electric so wasn't on all of the time like a belt driven fan so this was quite a bit safer lol

Hey Steve,

Mate I hate to say it... But check out your oil pump.

Mechanics taken all my belts off, still there. Taken off timing belt and swapped pullys etc. Still there.

Hes put a screwdriver where the oil pump would be? and is certain its the oil pump. He was blown away but swears it must be gears rubbing on the backplate or something. Oil pressure seems fine. Im fkn fuming because ive only had this engine in for aprox 600km and its causing me so much problems. I hope the oil pump is not your prob, but sounds VERY similar so check it out. Good luck to you Sir.

Hey Steve,

Mate I hate to say it... But check out your oil pump.

Mechanics taken all my belts off, still there. Taken off timing belt and swapped pullys etc. Still there.

Hes put a screwdriver where the oil pump would be? and is certain its the oil pump. He was blown away but swears it must be gears rubbing on the backplate or something. Oil pressure seems fine. Im fkn fuming because ive only had this engine in for aprox 600km and its causing me so much problems. I hope the oil pump is not your prob, but sounds VERY similar so check it out. Good luck to you Sir.

Cheers man, I will get my mechanic to look at it when I take it in for a service in about 1000kms or so. I got my stepdad to look at it, for a better opinion, he said it isn't anything that I should be worried about. Good enough for me :)

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just trying to get my head around this. At 5psi of boost, you turn on your wmi pump, and then you're using a 3000cc injector, to allow flow upto the actual engine, where you have your 6x200cc injectors and a 500cc injector. If the above is correct, what advantage are you obtaining by having the 3000cc injector blocking flow, is this just incase a line breaks between that injector and the motor you can stop flow immediately? Or are the 6x200cc and 500cc less injectors and just spray nozzle?
    • Welcome! New member myself, but I had an R33 back in 2002. Best advice I could give, based on my experience: if you're running the factory turbo, be very conservative with boost. I made the mistake of just fiddling around with the boost controller and cranking the boost for fun, and the end result was my intake pipes popping off frequently from the constant deluge of oil that was being blown into the recirc by the stressed-out turbo, which itself was siphoning oil from the engine and farting it out both sides of its centre bearing (or something to that effect). If I could do it all again, I would have gotten a new turbo and had a tune dialled in professionally and then just left it alone! Funny you mention the metal shavings in the gearbox, as I had the same thing - the probe plug (magnetic drain plug, essentially) would come out caked with shavings. At least it was doing its job. Not sure if that's just sacrificial wear and part of the deal, or if my gearbox was shagged, but I wasn't abusing it. Enjoy the R33 - they're a dying breed, and if they weren't $35k+ on CarSales in Queensland, I might have picked up one of those again, instead of the 370GT I own now (though I'm loving the 370GT, that big 3.7L V6 just hits different).
    • Howdy folks. I owned an R33 back in 2002, which was thoroughly beyond my capacity (financially speaking) to maintain/insure, so we parted ways in 2004. Fast forward 21 years (to literally yesterday, in fact) and I'm now the proud owner of a 2007 V36 370GT. I'm happily surprised by how much power the VQ37VHR makes, compared to the RB25DET, considering the latter is turbocharged. I had planned to add a turbo at some point but I'm on the fence about whether I'll even need it (though I do love the sudden onset of extra torque). Any other 370GT owners around the traps, I'd love to hear about your experiences with this car (good and bad).
    • Perhaps the answer is... more jacks!* *proper jacks must be used.  
    • I NEVER think about using a scissor jack unless there is absolutely no other alternative. f**king things are dangerous, annoying and stupid.
×
×
  • Create New...