Jump to content
SAU Community

Recommended Posts

Hmmm... looks like my car has been treated much better than yours.

2860-5 blown turbo, all it needs is a new cartridge for it,a lot cheaper than buying new one. 500$$ Call anytime 0423953016

I need a camshaft for my Gtr 33 cause it has shit itself.thanks Tom 0423953016

So when did you build the engine? Sounds like your car has some problems or maybe driver abuse...

hey would like some answers i bought a gtr 33 its standard apart from the mines computer, arc cooler, greddy radiator,hks turbo pipes from the cooler,apexi twin intake with k&n pods,3.5 inch exhaust? also doesnt have a boost controller and if i were to wind boost up just a bit how could i do it??thanks

Lol.

So he blows his engine rebuilds it forged goes 400 awkw daily weapon gtr which will shit all over yours and wave to you as your on the side of the street with a canary in your front window. Huge defect bill logged with the police for everytime you go through an RBT or plates are run. He will still spend less than you.

Where is nismoid?

Pity I'm on my iPhone there is no banned emoticon to add in. But id vote for ya. Vote +1 for above.

Hadouken totally got the jump on me. Lol shannanigans. Lol. Sau stalk lol. Btw above was about his car not yours. Seriously dude. Glutten for punishment much. This needs to be locked before its a ban a thon. Has been fun though. I'll make sure to by some seconds off you bra bra.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...