Jump to content
SAU Community

Recommended Posts

This is for my parents Honda car. I want to replace their steering wheel, but need to disconnect the battery so I don't trigger the airbags. Problem is once I disconnect the battery, the alarm goes off. It's a mongoose, though not positive as to what model. I have that little key, which I used on the alarm speaker thingy and it seemed to shut it off ok. But upon closer inspection it's still actually chirping away, be it at like 2% noise instead of it's regular 100%.

The siren speaker looks like this

MSP80.jpg

If I was to take this thing apart, is the battery backup battery inside this thing?

The alarm works ok. If I have to I'll let it chirp for 10mins or so while I take the steering wheel off, then unplug the airbag connectors. Connecting the main battery terminals stops the chirping and everything again works as it should. So it's only during the period I have the battery disconnected so I don't trigger the airbags, that I want to shut the alarm off. Using the key on the siren shuts it off, but only 98%. Put your ear close to it, you can still hear it. If that's all I have to deal with for 10mins or less I'll live with it. I don't think getting a new alarm is going make any difference and seems excessive for simply wanting to replace the steering wheel.

Chris is right.. new siren.

As far as I know it's a sealed siren.

In frustration I cut the wires, pulled it out and couldn't crack it open.

I smashed mine open because it just would not stop. Suppose I could have drowned it !

There is like 8-10 disc batteries rolled in clear plastic.

Sounds like it got wet , the keyholes leak , even 1 drop and it shorts the key curcuit

Drowning it wont stop it , i tested my old one in a bucket of water , it sounds wonky but still going off and got louder as it dried again ( it was farked but still going )

New siren time , 99 bucks

Drowning it wont stop it , i tested my old one in a bucket of water , it sounds wonky but still going off and got louder as it dried again ( it was farked but still going )

Old siren still has 3 uses...

1) insert into coffin for burial > frightens graveyard vandals away

2) additional location device for searchers of black boxes from ditched aircraft

3) place under mother-in-law's bed to remind her that she's forgotten to take her hearing aids out before retiring

;)

I had the same alarm. turning the key on the actual siren only makes it a bit quiet like you said. but i dont see why you cant leave the siren chirping at a very very low volume which you can barely hear, for a while. i left mine like that for about two days and then put it back on.

I got it all sorted. Turned the key, unplugged the battery and it did it's near silent chirping business. I got on with unplugging things, replaced the steering wheel and then reconnected everything. Once I connected the battery back again, the chirping stopped. Then turned the key to put it into normal mode and it's all working good again. This took 5-10mins.

I can live with the minor fault of it not been entirely silent when the key's turned and the battery is unplugged. That's not an everyday situation either so not like I'm going to have to deal with this on a daily occurrence.. As it stands right now, the alarm arms, chirps, and goes off just fine.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Bah! I can't see the point in custom number plates at all. I went to the rego office, fished through a box of "premium" plates (the ones that had the "not as tall" option for the front plate) and picked the one that had a 32 in it. That's the limit of the effort and cost I will put into number plates. The only plate that I'd consider paying for would be 2332, but that's not possible here because it already exists from probably 90 years ago, and it would cost a fortune to obtain it, if it were available.
    • After chasing my tail with LS results..... and cheaper than a turbo swap... How confident are you that the dyno is accurate relative to other results? How fast is the car - What MPH does it actually run? Is this similar to what people running this power would expect?
    • Hi mate I am having an identical issue with my 98 R34 GTT. The engie suddenly cuts out under load at about 3-4k, black smoke out exhaust. Almost feels like traction control kicking in. No CEL but still going to check codes later today. Car was sitting in the shed for about 5 months before hand and only idled a few times, took her out with about 1/4 tank, filled up and thats when the issues started happening.  Threw on a spare set of coils/harness and checked plugs which was no help. Recently had fuel pump/filter changed so surely thats not the issue unless condensation in fuel, I just havent had the time to drain it It's running a hi flow turbo, bosch 1000cc injectors, walbro 450L, Z32, Nistune etc... All about 2000km old.
    • I always wonder where the obsession with legal/illegal spacing on number plates in the UK comes from. Because it comes up in comments in every UK-based video I see on youtube. From my point of view all of your plates look a bit odd. Just because there are no markings whatsoever. In Australia we have the state that has to be on it. In Europe you get stamps and state logos. Yours look a bit like a throwaway draft that people then stuck with. And attached with blu tack so that it falls off at the slightest disturbance. Not trying to hate, but it's interesting how things are done in different countries. Do you have to follow a lettering convention when choosing a custom plate?
    • Hybrid sounds like a supercharger... It's half a turbo, with a belt to drive it! Oh wait, they're just called super chargers...
×
×
  • Create New...