Jump to content
SAU Community

Recommended Posts

Just found out that the law doesn't require me to have a cat. so I've decided to get some pipe and make a few flanges. Anything to look out for when i'm doing this? i know there's currently a temp sensor but i just want to cable tie it out of the way for now.

Also, will this give the car a better sound? as it already has a nismo 3" exhaust. is the cat holding me back from a better note?

Cheers

http://www.youtube.com/watch?v=bsIrz_LaHdo

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/
Share on other sites

Pretty sure the law says you need a cat !! If the car came from oem that way , your not going to feel a lot of power over a hiflow car , only noise that makes it sound faster

A decrease if your cat expands pipe goes from 2.5 ,3 to 5in the air turbulence actually makes less power

Plus smells like hell to idle

The fine is huge if your not running a cat or shop removes it for street use

After running no cat on NA rx7 for 11 yrs except for 15 min california style emissions test only to remove it again , on that full race motor i noticed it a lot but the factory intakes etc had to be put back on to pass too and a bottle of emmisions pass junk poured into the tank for the test on bridgeport motor

Its not worth it buy a 100cell for 200 bucks which is sorta legal anyway

Can be drone at speed which is super annoying

My 2 c

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6471385
Share on other sites

I gutted my 3" cat and felt and heard no difference. Kakimoto 3" exhaust.

But there was the occasional bang of a back fire changing gears or just backing off the accelerator.

And yeah I'm pretty sure by law you need to run a cat. I think if the car is pre '85 (or somewhere around there) then no hotdog or cat required, just mufflers.

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6471431
Share on other sites

Carbon 34,

OP is from NZ - cats are not a requirement there, I'm lead to believe.

I thought the same thing, but I believe this has been revised.

http://www.transport.govt.nz/legislation/Vehicle-Emissions-Questions-and-Answers/

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6472514
Share on other sites

Cheers for the input, the car is registered as a special interest vehicle (used to exempt cars from NZ regulations on frontal impact and emissions) which the R32 GTR classes as.

The car sounds quite droney already and it does occasionally spit when on the overrun and changing gears, see what the story is on the weekend.

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6472518
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...