Jump to content
SAU Community

Recommended Posts

hi folks,

got a new problem with the car i haven't encountered before.. as a background.. my battery ran flat last week so after getting it recharged at the shop few days later.. i think i can hear det on light load.. i have a wideband wired in and on idle it used to be 14 odd now its constantly low 13 afr.. also when accelerating smoothly i can see my afr dipping into low 12 sometimes 11 on the afr gauge..

my suspect is the fuel pump failing due to the perhaps too much draw placed on it while i was using a semi charged battery.. could perhaps be the FPR, fuel filter or bad earth.. in either case.. im looking at changing the fuel filter and putting fuel pressure gauge in to check pressure this arvo

currently i have a sard fuel pump in there.. no odd noises.. primes fine.. no hesistation from the car.. i do have pretty bad fuel economy of late and car doesn't feel as nippy as it used to.. i have read past thread on dying fuel pump but would like to hear if i have missed anything out, will look at getting it on a dyno for a run but that could take a week

Link to comment
https://www.sau.com.au/forums/topic/408567-can-the-battery-kill-the-fuel-pump/
Share on other sites

good point.. although i only run bp98.. the thing is i dont get the knock light flashing (pfc), so may not be getting picked up but sounds like det.. got half tank left, maybe drain it and put a fresh batch in..

when i had the car at unigroup earlier this year, yavuz did comment that its leaning out a bit at the top but wasnt sure if it was fuel pump or voltage or fpr

So it's running richer now than before?

Typically electric motors don't slow down after being subjected to low voltage high current situation unless its absolutely fingered and would barely work at all. But I would imagine all fuel pumps are brushless so makes it even more impossible

So it's running richer now than before?

Typically electric motors don't slow down after being subjected to low voltage high current situation unless its absolutely fingered and would barely work at all. But I would imagine all fuel pumps are brushless so makes it even more impossible

Exactly what I thought. It sounds like its running richer if anything now

11-12:1 AFR should be OK under load as long as your tune was done properly

right u are lads, running richer on idle n on boost (seeing low 11's), car never ran this rich so I'm about to clean the afms again n pressure test

not sure what the pinging noise is though, fuel pump -ve is grounded to chassis to bypass fpcm

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...