Jump to content
SAU Community

Recommended Posts

hey guys

i had my car's timing belt changed and dyno tuned this morning.

i have noticed this afternoon that when i accelerate it completely loses power like the fuel has just been shut off and you get whiplash from that alone.

any ideas what this could be?

Link to comment
https://www.sau.com.au/forums/topic/41029-loss-of-power-while-accelerating/
Share on other sites

it seems to be fine now

it was only on my way home from work it done it.

when i went out that night it done it just a touch, but most peopel wouldnt notice. today i given it a little squirt and it seemed fine.

maybe tomorrow night it will do it again :P

If it does it when it the air temperature is cold, it is overboosting and giving a fuel cut, you should probably run a lower boost setting when this happens. this happens to my car at partial throttle when it is cold, if i give it full throttle it is ok as the boost bleeds off enough to stay in the safe zone.

or it is something completely different!! :P

mine did this tonight, felt f**ed

last week i had fuel pump upgraded, spark plugs changed to ngk coppers at 0.8gap... car never used to do this before, and even yesterday i have revved it out on full boost and it was fine. happened tonight on 3/4 throttle on boost at low revs 2-3k, engine fully loses power and gives u mini whiplash and then keeps going along as if nothing happened. if i keep it off boost until revs are higher than plant it, it's ok.

also since had fuel pump upgraded and plugs changed, seems as though theres a slight miss at idle every so often. can feel a slight pulse every now and then at idle. any ideas?

If your fuel pump flows more then there will be a pressure increase at the injectors resulting in more fuel being injected. Therefore the idle is richer and will change the way the engine idles. Whenever you change the boost, fuel system, or intake (Intercooler) you need the ability to tune the engine to achieve ideal air fuel ratios. This is why aftermarket computers and fuel computers like the safc are so popular. I need one for my car and the only mods i have so far are increased boost and a cat back exhaust.

  • 1 month later...

Keep us updated on this issue because my car recently has this problem as well. Runs fine most of the time but once in a while (but more often when cold) stutters at 2-3k rpms. I also noticed my oil pressure rising when this happens...if I let it idle a bit(step on clutch) then accelerate again, all is fine until oil pressure rises and it stutters. Only problem is that it doesn't do it all the time.

I'm looking at the spark plugs over the weekend and will post again about it.

PS: car also had timing belt changed recently!

EDIT: I know this thread is old, but it is still unresolved IMO! :blah:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • In the US almost everything is E10. It can't exceed 10% by much or fuel systems have trouble adapting. At the same time because MTBE, MMT, and TEL are all banned they need as much ethanol in it as possible to boost octane.
    • I was mostly jesting. In my experience (and probably only my experience) the R34 GTT physical airbox space is actually too small to flow the amount of power it wanted. By sealing the box, I made it so it could only be fed by the ducts themselves. So you can seal it up and get nice cold air which IS good, but at a certain crossover point: More Hot Air > Less Cold Air I don't think you're at this point. In my case merely ducting the hot air intake with a very focused set of ducts counteracts the fact it's in a V8 engine bay. More cold air obviously best. The solution looks great.
    • Nah, the OEM CAI pipe is still installed behind the bumper, it is about 5" x 3" oval at the engine side, tapering down to a 3" pipe behind the bumper where it gets all the ambient air it needs Engine side of radiator support OEM intake pipe "oval hole" that is right in front of the filter My OEM NC1 CAI pipe: From NC2 onwards, below pic, they come slightly smaller at 2.75" diameter with corrugations and a resonance chamber to reduce intake noise, lucky for me my NC1 has the bigger noisy one, LOL   Basically, the "sealed" airbox will just get ambient air from a 3" pre filter intake tube that is the same size, 3" as the rest of the intake pipe post filter, and if a 3" intake isn't big enough to flow enough air for 150 killerwasps then there are other issues The whole intake is basically the same length as OEM, but it is now about 30% bigger from the airbox back through to the new intake plenum than OEM, and the intake plenum is port matched to the head And the intake is now about 30% bigger than my 2.5" exhaust, so the suck, squeeze, bang and blow black magic should be fine, well, to my uneducated understanding of fluid dynamics anyway Talking the the guys at MX5 Mania, it may even make a few more killerwasps as the intake isn't sucking hot air, especially off idle or when in slow traffic when it would be sucking hot air  As for the difference in IAT, I haven't logged IAT yet, as I don't currently have a OBD2 reader, but I will have a play with my thermal lazer thingie next time I take the car out to sèe how hot stuff gets under the bonnet near the intake filter prior to installing the air box, my "assumption is it has to be much better after the air box is in and sealed up compared to what it is now The aftermarket "performance" CAI elephant in the room: Aftermarket CAI intakes typically have the air filter tucked up behind the bumper, with a 2.5" intake tube (the OEM intake pipe is actually about 30% bigger than the fancy pants "aftermarket" version.....WTF), and you need to remove the bumper to service the filter, which is a PITA Like dis:    
    • Nice one, I'd argue that the white S1 RS260 is certainly the best looking of the Stageas. And yes, fully agree on the forum situation. It's a bit of a shame, but at least SAU is a good place to be. I found the facebook groups to give me FOMO because people were trying to one-up each other and show off in some way. Feels much more natural here. There are people with seriously nice builds, but I can appreciate it rather than it making me question my life choices. Might be that people are more open with sharing how much work/money/suffering it takes to actually get there. 
    • Evening, wanted to pop in and finally register to say hi to everyone here on SAU!   It's been a while since I've been active on a forum, but back in the day I used to be relatively active on ClubLexus and other hobby-related forums. I'm glad to see SAU is still around, since with the advent of Facebook and Discord it seems forums aren't what they once were. As a recent new owner of an S1 260RS Stagea, I've found so many older guides and helpful tips from SAU that I figured I needed to join and say a grave thank you. My recent acquisition has only become legal in the US for the past year, and knowing that similar car enthusiasts from across the pond have already figured out the kinks and tricks to get these 25+ year old cars running well. I look forward to diving into more of the SAU forums as well as hopefully contribute some info myself for future posterity.   As a pic tax, here is one of the few good photos I have of my Stagea. I hope to get way more in the future!    
×
×
  • Create New...