Jump to content
SAU Community

Recommended Posts

Made 520whp on GT-SS.Now, I just swapped to -5, added water-meth and charge pipe.

Just wondering when the 3 inch exhaust become restrictive?

( Suck because I like the sound of mine and bought a 150$ ultra-quiet resonator as a test pipe, varex electric valve and one extra muffler, I heard that 3.5 inch exhaust sound a bit too rumbly isn't it ?)

Made 520whp on GT-SS

I highly doubt it.

What fuel?

But to answer your question, normally 3inch cat back will be ok for 450hp at the wheels.

Most of the important stuff is before the cat so it depends on what you have there

I wll say it again ( I got bashed before on this forum). I don't care if ppl don't believe my number. I'm not a showoff and couldn't care less about bragging my setup/numbers online. Number are only for reference not for bragging.

Fuel is 94 octane.

So what I should do is get a Y pipe ( front pipe, we call it?) 3.5.. TRY to find a resonator 3.5 inlet and 3.0 outlet. That will be the hard part.

Going up and down .5" doesn't really need different flanges. I.e. you can bolt 3" to 3.5" so long as the bolt holes are in the same spot. I'd imagine it would flow a bit better with matching flanges though...

I wll say it again ( I got bashed before on this forum). I don't care if ppl don't believe my number. I'm not a showoff and couldn't care less about bragging my setup/numbers online. Number are only for reference not for bragging.

Fuel is 94 octane.

So what I should do is get a Y pipe ( front pipe, we call it?) 3.5.. TRY to find a resonator 3.5 inlet and 3.0 outlet. That will be the hard part.

Well it matters how much HP you ACTUALLY make because you are asking how much HP your exhaust can handle.

If you make more HP than you should be able to on the pipes you have then nothing you are told is going to mean shit

What mph does it run at the drag strip?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thank you, 100% the intent. New coils were due and the 17" sixers look/feel loads better than the stock wheels. The aero options are so spot on.   Thanks for the warm welcome, all!
    • 98 r34 gtt Been rocking my latest setup and car running like never before. Have put a good 200 miles on it since all the latest changes and additions. everything is dialed in and have been driving it a bunch.   However, all a sudden last weekend as soon as I pushed throttle passed 4k and the engine stumbles, (slow or fast acceleration) hesitates and doesn’t go above 4100 or so, like a misfire. Everything else seems fine. I had a “good” set of coil packs that I removed from car when I first got it when I changed them over to new coils. I swapped out current ones for those, but no change. I also changed the plugs, no change. Seems to rev over 4 when out of gear with no load just fine no “misfire”, but as soon as its in gear with a load of any kind, it “misfires” as soon as rpm drop back below 4 k it runs perfectly, smooth, starts, restarts and drives fine as long as I keep it below 4 k while in gear. All readings look fine, no CEL   Any idea as to what could all a sudden cause an issue when pushing rpms passed 4 k?
    • When you say your cams are 272/262 is that 272in and 262ex?
    • We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
×
×
  • Create New...