Jump to content
SAU Community

Import Monster Sauvic Deca Motorkhana - 8Th December 2012 - Entries Open


Recommended Posts

At last check there were 5 spots left.

A lot of people are asking about paying to get on the list. Forms get you on the list, payment keeps you on the list ;-)

We will have a reserves list as said above. There are normally a few that drop out. Please make sure you have a mobile number on your form so we can call you if there is a spot.

The list will be updated in the morning.

  • Replies 195
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Even if the lsit fills up

get your entry in (but hold off on payment)

you will be on the reserve list

if people don't pay in time or need to pull out you will get bumped up and can pay at the time.

I've got in on that method b4.

not the quickest i've seen a deca sell out but fastest for a few years.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...