Jump to content
SAU Community

Recommended Posts

so i finally went to the exhaust shop n got it checked out. turns out my control box isnt working (the little black box that reverses polarity n that) they're asking for $70 for a new one with the remote. I've barely got any cash at the moment and was wondering if anyone knows of any places to get them cheaper?

or better yet, i've heard there are ways to by pass the box totally, and just have it wired to a switch or something? i get it takes 12v to close and something about reversing the polarity to open again?

I found this diagram on the internet, is this correct? I don't really understand what its saying. hopefully i can find someone that does :ses5lro.jpg

or this this the correct diagram bellow?

post-78310-0-59408300-1357141955_thumb.jpg

Edited by hop1308

couldn't figure out how to do the wiring at all. just bought a new control box and remote. works a charm.

car sounds stock with the butterfly closed.

I've looked into the legality of it, and it seems the whole system itself is illegal no matter what. because there is a way for that exhaust to be louder than the legal limit, and it can be called a noise cloaking device or somethin like that. not too sure how to get around this if i get pulled over lol

the massive VAREX written ontop of the cannon itself doesnt help. i wish i could sand it off.. seriously considering just putting black tape over it lol, but that might draw more attention to it :\

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...