Jump to content
SAU Community

Recommended Posts

what I did "today"(long weekend) was change from compliance side repeaters that look like nipples to aftermarket IS200 items, and pulled my dash apart and re-wired/re-soldered my stereo.. keen to get fender braces in, cos you know, dodgy/floppy toyota.. etc

Edited by Scar

hey, theres one of these threads in the wasteland.....

:P

you know, for everyone, not just the Awesomeness that is SAU ACT.

Twas what inspired me to start this thread.

It's good to hear more local vehicular happenings rather than randiness randomness from randy random wastlanders. :D

Twas what inspired me to start this thread.

It's good to hear more local vehicular happenings rather than randiness randomness from randy random wastlanders. :D

well sooooooooorr eeeeeeee.

all good.

hijacker.

all good.

hijacker.

indeed.

Trollorist. :)

Put my boot trims back in to finalise my Rear Strut Brace Installation

Looks like it was always there, and gives me somewhere to attach my bag of tools/jack etc.

Hilux:

removed diff u bolts and measured pin.

ordered longer u bolts.

already have blocks ready to go.

will be lowered next week.

skyline:

removed steering shaft.

test fitted radiator.

fan doesn't turn.

removed radiator.

removed fan.

reinstalled radiator.

test fitted oil return.

Cleaned Prelly FS, jumper started Emo (doofus left headlights on), pushed GTR back so Troys fireblade fitted in garage eezy peezy, and domestics :( (cleaning not fighting)

isn't cleaning just another term for fighting dirt and scum build up?

so, you were fighting....

Won an ECUtalk cable on Ebay.............................Cheap. :woot:

I just can't wait to slam my lappy shut and lose the floor pan. :D

Skunnabeesweeet!!!

Won an ECUtalk cable on Ebay.............................Cheap. :woot:

I just can't wait to slam my lappy shut and lose the floor pan. :D

Skunnabeesweeet!!!

dont forget to yell shhut up at it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...