Jump to content
SAU Community

Recommended Posts

Old gearbox mount is starting to peel off the rubber.

Looked for the cheapest fix so i put in one of those GKtech solid mounts.

Holy crap it makes the whole car rumble, and the gear whine is full on! And thats only backing up the driveway! :O

Maybe a bit harsh for my liking. I think its more of a full on race car thing.

Braided clutch line in, bit of a pain to bleed it.

Have to test drive and see how it goes.

Edited by D.I.Y. Mik

Solid gearbox mount is too loud, has to go.

Bad shudders under acceleration, some problem that i can now feel cos of the solid mount.

Must diagnose and fix.

Richard, nice wheels, and i have to give back that boss kit sometime.

Edited by D.I.Y. Mik

Replaced my left front upright because old one had damaged eye bolt that the coilover mounts to. Gave everything a nice clean ready for some cruise tomorrow :D

Rob esp are good with safc's so is auto tech hume albeit more expensive

Auto tech is Hume 100% just got my car back from them after being there a week. I'd say I'm happy with Ed's tuning and service. Car is running good. Ed tells me he don't really like haltech but he tuned it so well. I'd defiantly recommend Ed and the Autotech team with out hesitation.

After getting my car back id just like to tip my hat to Adrian and the guys at ultimate tunes for the finishing touches on the GTR. It drives and feels incredible. It has never ran so well. Couldn't be happier.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...