Jump to content
SAU Community

Recommended Posts

A recent decision of the Consumer Trader and Tenancy Tribunal in New South Wales considered a claim by a landlord for the replacement of the bed allegedly damaged by the tenant during the tenancy.

The landlord claimed for the cost of the replacement of the mattress and base. The Tribunal found that the bed had been purchased 9 years before the end of the tenancy in question, and accordingly awarded the landlord 6/15 of the cost of replacement.

9 + 6 = 15. Therefore a bed has a life expectancy of 15 years.

Teacher Housing Authority of NSW v Williams (Tenancy) [2008] NSWCTTT 890 (20 March 2008)

Link to comment
https://www.sau.com.au/forums/topic/418871-life-expectancy-of-a-bed/
Share on other sites

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Question is does increased use of bed effect life expectancy?

Also, I am disappoint at no dodgy link to put my bank details in.

Could be like exercise, more is better?

And yes, i have PM'd my Credit Card details to hopefully get a start on a new bed!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
×
×
  • Create New...