Jump to content
SAU Community

Recommended Posts

hello gentlemen,

now and then i get a weird sound felt thru my foot on the pedal, and only on boost and sounds like a vrrrrrrr and coming from the front right side of the car ,as soon i take the foot off the gas it goes away i thought wheel bearing but thats been done. may be awd problem or aws or some thing i don;t know ideas any body. ;)

cheers rudi

Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/
Share on other sites

Could it be the farting BOV problem or have you already replaced the BOV?

http://www.skylinesa...327936-m35-bov/

It was a problem on mine and replacing the part cured it but yours could be something different.

HTH,

Jas

Edited by HER_M35
Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/#findComment-6748454
Share on other sites

It will most likely be the BOV Rudi. Try sliding a sheet of coke can under the bov as a test, it will make completely different noises then. Zutututu. :)

All the ones I have here do the same thing, it's just play in the plastic disk that causes it I think. The Turbosmart Kompact plumb back works well if you want to upgrade, or perhaps a GTR BOV would work?

Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/#findComment-6748564
Share on other sites

It will most likely be the BOV Rudi. Try sliding a sheet of coke can under the bov as a test, it will make completely different noises then. Zutututu. :)

Bov up grade I like the sound of that:) cheers

All the ones I have here do the same thing, it's just play in the plastic disk that causes it I think. The Turbosmart Kompact plumb back works well if you want to upgrade, or perhaps a GTR BOV would work?

Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/#findComment-6748575
Share on other sites

If you have driven one with the BOV blocked you may change your mind, it can ruin the part throttle response and make the car jolt badly, mainly when dropping off boost.

As there is nothing stopping the compressor, and no purge, you will get boost spiking, perhaps up to 50psi in the intake. This can cause pipes to split or pop off, as well as damaging the turbo. Just not worth it imo, other than the stupid noises that scare the chicks away...

Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/#findComment-6749118
Share on other sites

+11ty billion!

The sound of it zutututututututututututuing it's head off drove me mad in about a minute & a half when I was troubleshooting with it blocked off.

And as Scotty says; the car feels like shit with it blocked off, to say nothing of the potential damage.

I must be getting old; cos I would have sold my sould for that noise when I was 20. :domokun:

I've got a shim made up if you'd like me to post it out to you Rudi, then you can at least eliminate it as a potential fault. ;)

Edited by Daleo
Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/#findComment-6749138
Share on other sites

+11ty billion!

The sound of it zutututututututututututuing it's head off drove me mad in about a minute & a half when I was troubleshooting with it blocked off.

And as Scotty says; the car feels like shit with it blocked off, to say nothing of the potential damage.

I must be getting old; cos I would have sold my sould for that noise when I was 20. :domokun:

I've got a shim made up if you'd like me to post it out to you Rudi, then you can at least eliminate it as a potential fault. ;)

that would be great, cheers dale
Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/#findComment-6749168
Share on other sites

Scotty, you love ztuuzuzuzuzuzuzing. You said so in my car......

And you remember seeing all the Golburn girls getting excited at ztuuzuzuzuzuzuzing ?

Sounds hawt!

Which one of them had the community tooth that day?

Link to comment
https://www.sau.com.au/forums/topic/419842-weird-sound/#findComment-6749651
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Look for broken wire or bad connector at the motor. Might not be it, but is worth starting there, as it is easy.
    • Hi everyone, I’m having an issue with my R32 GT-R. Sometimes, when the car goes over a bump or experiences some vibration, the 4WD warning light comes on the dashboard. When I check the code from the control unit in the trunk, it shows Code 19 – ETS Motor. However, everything seems to be working fine — if I turn off the engine and restart the car, the light goes away and everything functions normally. Has anyone experienced this before? Where should I start troubleshooting this issue? Thanks in advance!
    • I'm back from the dyno - again! I went looking for someone who knew LS's and had a roller dyno, to see how it shaped up compared to everything else and confirm the powerband really is peaking where Mr Mamo says it should. TLDR: The dyno result I got this time definitely had the shape of how it feels on the road and finally 'makes sense'. Also we had a bit more time to play with timing on the dyno, it turns out the common practice in LS is to lower the timing around peak torque and restore it to max after. So given a car was on the dyno and mostly dialled in already, it was time for tweaking. Luis at APS is definitely knowledgable when it came to this and had overlays ready to go and was happy to share. If you map out your cylinder airmass you start seeing graphs that look a LOT like the engine's torque curve. The good thing also is if you map out your timing curve when you're avoiding knock... this curve very much looks like the inverse of the airmass curve. The result? Well it's another 10.7kw/14hp kw from where I drove it in at. Pretty much everywhere, too. As to how much this car actually makes in Hub Dyno numbers, American Dyno numbers, or Mainline dyno numbers, I say I don't know and it's gone up ~25kw since I started tinkering lol. It IS interesting how the shorter ratio gears I have aren't scaled right on this dyno - 6840RPM is 199KMH, not 175KMH. I have also seen other printouts here with cars with less mods at much higher "kmh" for their RPM due Commodores having 3.45's or longer (!) rear diff ratios maxing out 4th gear which is the 1:1 gear on the T56. Does this matter? No, not really. The real answer is go to the strip and see what it traps, but: I guess I should have gone last Sunday...
    • 310mm rotors will be avilable from Australia, Japan, and probably a few other places. Nothing for the front can be put on the back.
    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
×
×
  • Create New...