Jump to content
SAU Community

Recommended Posts

Hi all. I just bought this Stagea today.

http://www.tradingpost.com.au/Automotive/Used-Cars/Small-Medium-Family-Prestige-Cars/AdNumber=D4020102402514

I don't know much about them being a rotary enthusiast, but I have a wife with a baby on the way and couldn't do a Camry.

Forgive me as I just signed up and will be reading all the information in the threads below in due course, but for now I wonder where you guys insure your Stagea's?

Where do you service them, and where would you recommend I go to have the car looked at to see if all is ok?

It has IMPUL and NISMO stickers in the engine bay and seems to "woosh" through whole rev range. It also has a boost controller so I assume something has been changed or do they all woosh the whole time?

Link to comment
https://www.sau.com.au/forums/topic/421587-hi-all-noob-stagea-m35/
Share on other sites

  • Replies 114
  • Created
  • Last Reply

Top Posters In This Topic

Nice car mate. There is definitely a few non standard things on it. Twin exhaust being one that stands out. Thewe cars have a single exhaust standard. Inpul also can mean you have stuff like a remapped ecu. But even standard they have a fair bit of go.

Now the maybe bad bits. I bought my car from ginza the guys are dodgy for sure. The guy who does there approvals for Australia doesn't do a lot of stuff. Make sure he has Changed your tyres as that's something I caught them out on and made them replace. They also don't do any servicing so make sure you get it a very good full service. If you bought his warranty make sure you contact the provider cause with me he threw it in to close the sale but then never logged it meaning I wasn't actually covered.

Hope this has helped but yeah very nice ride hope to see it around

Josh

Thanks mate. Car was advertised for 18 and I said I'll do 15 with one year warranty.

I also had a look under it and said what it that exhaust doing attached to nothing? Not a fan. So he said he will remove it today.So that's gone.

He seemed to know less than me which is always a worry. He said it was a twin turbo and even I know it isn't.

It has these strange badges though. It says infinity across the rear and it has an infinity front badge and also says ARX-Axis in the back.

I can't see any reference to Axis model cars on the net so far?? Any idea??

No the exhaust was purely aesthetic. So it is no longer there.

It seems the Japan owner has put newer model parts on such as the front bumper and mirrors with indicators on them. That's what it seems like to me.

The car itself seems to run and sound fine but I am keen to book it into a work shop somewhere and have it serviced and assessed asap.

Do you guys have a preferred place you service your Stagea's?

I do it myself. You can also hit up Jetwreck on here. The guy is the man in Sydney for m35s. Not sure if he does much in the way of servicing but I would recommend him to you as far as someone to have a look at it

People are stupid that's why. Just be aware when removing badges. The standard ones on our cars are fitted when the paint is still soft so sometimes you will end up with raised lines around the badge. Shouldn't be an issue with the after market ones.

Thats a PNM35, i dont think its arx, it looks like axis to me and whats with the badging overload? :no:

Nope, its an NM35 with PNM35 headlights. The VIN checks out for NM35. Its definitely an AR-X and should have the radar cruise control

Agree with Dunc ^. ARX

It is a little confused that car.

The Impul if still fitted will most likely refer to the ECU. The Impul ECU does a few special things like remove the 180km/h speed limiter, remove any boost cut and adds a bit more fuel.

The Nismo S tune sticker could be Nismo springs and shocks. If they are there, the springs are red in colour.

I notice there are a few things under the dash also.

The car is dead easy to service your self. Have a read of some of the sticky threads about servicing.

GL

if you don't want the Infiniti Front Grille I have the standard ARX Grille here for trade.

I suspect the front bumper bar would need to be changed at the same time.

If your interested, I'd consider a swap.

My coupe has an Infiniti grille so it would kinda match up nicely.

if you don't want the Infiniti Front Grille I have the standard ARX Grille here for trade.

I suspect the front bumper bar would need to be changed at the same time.

If your interested, I'd consider a swap.

My coupe has an Infiniti grille so it would kinda match up nicely.

Given that this car has had the series 2 front end fitted, better check with Cam, who did this swap previously, to find out if they are interchangable...

I do remember that this "simple" swap was a huge pain for him...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
×
×
  • Create New...