Jump to content
SAU Community

Recommended Posts

yep I have the entire centre console.

gtr peices sold yesterday sorry.

msg me on 0421551710 and ill send yiu pics of the centre dash

Hey Jarrad - maybe you could help me with the R34 GTT boost sensor?

Looks like this

Located at the back of the block and the tube to it is normally blocked off.

bonnet was damaged so we tossed it

pod box

http://m.gumtree.com.au/nissan-skyline-r34-gtt-pod-filter-box-cai/v?adId=1025086477#pod box

hey the sensor went with the engine sorry.

anything attached to the engine is gone

Hey mate

Steering Column Cover top and bottom pieces?

Boot Carpet pieces $50?

Also after a few random dash pieces

Cheers

Edited by green180sx

Is it a series 1 or 2?

If its a series 2, I'd be keen on the drivers side guard. In Adelaide, so would need to orgainse shipping but thats not too much hassle providing it can be packaged suitably

Chris

sorry manifold went with engine.

i think it was a 99 model, not to sure if it was series 1 or 2 but i can get you a pic of the guard.

swing me a text on 0421551710 and ill send you a pic.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...