Jump to content
SAU Community

Recommended Posts

Friday, sounds good.

Got a hole in my front right tyre, its not all the way through, but it is into the belt.

Been doing some research, and there is a good method of repairing from inside the tyre. However it may not be good enough for Wakefield.

This:

A punctured speed rated tire brings with it additional considerations. While some tire manufacturers "allow" a tire to retain its speed rating if a specified multi-step repair procedure is followed exactly, most tire manufacturers reason that since they have no control over the damage caused by the puncture or the quality of the repair, they cannot confirm that the tire has retained its high speed capability. Therefore, their policy is that a punctured and repaired tire no longer retains its speed rating and should be treated as a non-speed rated tire.

Fresh brake pads and fluid going in this time.

And ill bring PLENTY of top up fluids too, its not hillclimbing.

Diff isnt leaking too bad, i will fix it before then if i can get a seal easy. Otherwise i can top it up if it needs it.

  • Like 1

Friday, sounds good.

Got a hole in my front right tyre, its not all the way through, but it is into the belt.

Been doing some research, and there is a good method of repairing from inside the tyre. However it may not be good enough for Wakefield.

This:

A punctured speed rated tire brings with it additional considerations. While some tire manufacturers "allow" a tire to retain its speed rating if a specified multi-step repair procedure is followed exactly, most tire manufacturers reason that since they have no control over the damage caused by the puncture or the quality of the repair, they cannot confirm that the tire has retained its high speed capability. Therefore, their policy is that a punctured and repaired tire no longer retains its speed rating and should be treated as a non-speed rated tire.

It'll be fine. Repaired a few of them with rubber inserts . It is really difficult to tear the belts on a tire. I'm pretty sure manufacturers err on the side of caution.

Fresh brake pads and fluid going in this time.

And ill bring PLENTY of top up fluids too, its not hillclimbing.

Diff isnt leaking too bad, i will fix it before then if i can get a seal easy. Otherwise i can top it up if it needs it.

Very good idea to bring top up fluids!

I have Project Mu mixed street/track brake pads and they hold up well, especially with the slotted rotors up front - still usable on the street too.

Make sure you also bring a bit of extra oil, as consumption increases a lot with a hot turbo on track (in my experience)

Brake bleed before and after will also make a big difference.

Also take a jerry can of fuel or two

  • Like 1

Tyre pressure makes a big difference.

Theres a big air compressor at the track, at the end of the sheds.

Im getting a good gauge, had to wait, hopefully they have stock now.

Also i have that temp gun, to see what temps were getting on the tyres.

Well unfortunately my leave wasn't approved.. Going to be too hard at the moment at work.. :(

I'll have to look into going another day some time in the future I suppose

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...