Jump to content
SAU Community

Recommended Posts

Who are you guys going through? I got my os88 through Jesse streeter. Cost me a little over 15k delivered to my door that's option 3 ratio, angled shifter and adjustable clutch fork. That's with no tax paid but. Say if I valued the gearbox under $1000. I did have to wait 5 months for the box to get made( out if stock apparently) and the 4 days shipping for japan. If that's any help

$15K sounds about right for an option OS88 box. Did you also get the OS88 cross member?

I would try Ben from Otomoto, he is awesome when ordering from OSG as he is the Aussie Distributor. If I reall , Fatz got a great deal for us earlier on in this thread. It all depends on the AUD-YEN rate.

I am out as I am already sorted, Paul ;)

Yeah...I just missed out on a complete bolt in kit with option two box that had a very low kms on it. But got my hands on another one through Jesse Streeter.

I couldn't wait 4 or 5 months.

It gives 40mm better ground clearance. Will confirm if it fits BNR34 as I have seen conflicting information about that: RHD says it's for all 3 models; OSGiken's website doesn't speciify; and Otomoto says it's for R32 and R33.

Let me know if you need one, Jim.

Paul, I already have a Direct Clutch billet twin plate, so just changing the plates to suit the 26 spline Holinger shaft of the OS88.

None of those sites have it in stock...it's all ex-OSG Japan.

Apparently, one of the companies that makes some of the smaller bits (such as the forks) for OSG went under so they can no longer supply it.

Try some other sites and you never know your luck :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Tried to make 1/8npt threads into compressor house of the turbo for my EBC. Threads got fu#ked and ended up with and elongated hole, so I do have good amount and nice threads 90% of the hole but 10% I only had 1-2threads there and rest of it is flush on that side of the hole.. So my idea is to do M12 x 1.25 to AN4 with braided lines instead of 1/8npt to 4mm vacuum silicone hose.  and hopefully get a better thread. M12 is quite big and AN4 is a little bit bigger than 4mm (4.9mm inner diameter braided PTFE hose). but this should work. Thoughts? Otherwise I will weld and adapter onto the turbo.   
    • Looks great, I hope everything is working well after all that time!
    • Finally back on the ground and once around the block for the first time in 2+ years
    • Ok a solution was found. I had left the factory oil temp sensor in and it was hooked up. My car never had the triple gauges.  Apparently when you delete the factory pressure and leave the temp sensor connected it triggers the oil light on the dashboard. Disconnected the temp sender, no more light.  I still haven't gotten around to look at the diagrams to figure out how/why they are tied together.
×
×
  • Create New...