Jump to content
SAU Community

Recommended Posts

Who are you guys going through? I got my os88 through Jesse streeter. Cost me a little over 15k delivered to my door that's option 3 ratio, angled shifter and adjustable clutch fork. That's with no tax paid but. Say if I valued the gearbox under $1000. I did have to wait 5 months for the box to get made( out if stock apparently) and the 4 days shipping for japan. If that's any help

$15K sounds about right for an option OS88 box. Did you also get the OS88 cross member?

I would try Ben from Otomoto, he is awesome when ordering from OSG as he is the Aussie Distributor. If I reall , Fatz got a great deal for us earlier on in this thread. It all depends on the AUD-YEN rate.

I am out as I am already sorted, Paul ;)

Yeah...I just missed out on a complete bolt in kit with option two box that had a very low kms on it. But got my hands on another one through Jesse Streeter.

I couldn't wait 4 or 5 months.

It gives 40mm better ground clearance. Will confirm if it fits BNR34 as I have seen conflicting information about that: RHD says it's for all 3 models; OSGiken's website doesn't speciify; and Otomoto says it's for R32 and R33.

Let me know if you need one, Jim.

Paul, I already have a Direct Clutch billet twin plate, so just changing the plates to suit the 26 spline Holinger shaft of the OS88.

None of those sites have it in stock...it's all ex-OSG Japan.

Apparently, one of the companies that makes some of the smaller bits (such as the forks) for OSG went under so they can no longer supply it.

Try some other sites and you never know your luck :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I like they don't raise their hands into the air when they shift their sequential boxes, seems to be a thing here in Australia lol...
    • I'm not normally one for posting random videos, but I thought we'd all appreciate the honesty about how broken our cars tend to be lol. Genuine skyline life here.   
    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
×
×
  • Create New...