Jump to content
SAU Community

Low Car Battery And Central Locking.


Recommended Posts

My central locking has progressively been getting worse over the past few months. Sometimes it works, sometimes it doesn't. Now it's gotten to the point where it never works. My headlights still flash as it arms and disarms the alarm, and my boot still opens consistently.

I thought it was the battery in the key fob, but I changed it, and apparently not. Some guy at Battery World tested my car battery, and said it needed recharging, that my short trips to work and back were draining the battery. This sounds plausible, except that I have no issue starting my car. Surely starting the car uses more battery power than unlocking and locking the doors? Or are our cars so smart that it diverts power that even when the battery is so low that the central locking doesn't work, that you can still start the car? I bought a low power battery charger, and after 12 hours of charging, still no luck. But then again it might take a few days of charging to be full.

Did I get ripped off? Does the central locking go before the ability to start the car does?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • I've got a Nexus for one of my other cars and I was surprised how simple it is to use and seems like a good quality bit of gear. The tech support guys are good to chat with too.
    • My point is more so focused on the division between cylinders 1 to 3 vs 4 to 6. Any low mount "bolt on" aftermarket manifold utilises an open T3 collector which has crap all scavenging effects. Sure it might allow you to slap in more timing up top to make a little more but you'll lose all the down low performance. Even Tao from @hyper-gear has experienced the same when modifying the stock manifold. He has experienced added lag by cutting out the divider inside vs. leaving it alone. Twin scroll works, even if the effort is focused primarily on the manifold and an open scroll turbine housing. Please don't confuse me with a V8 NA or Americans that thinks you need back pressure in a 4 stroke motor.
    • I bought mine from Concept Z https://conceptzperformance.com/hks-stainless-steel-catback-exhaust-system-full-dual-muffler-infiniti-q60-coupe-17-cv37-awd-rwd-31014-kn001_p_32626.php Put it on myself. Very easy jack stands. But if i was going to do it again i would get something like this   https://conceptzperformance.com/nissan-infiniti-infiniti-sport-exhaust-kit-axle-back-exhaust-system-infiniti-q60-17-coupe-cv37-b0100-q60st_p_30289.php Or just straight pipe it the whole way. I drove the car without an exhaust for shits and giggle when i was swapping it and it's not very loud at all. 
    • Ignore the monster truck ride hide, I messed up on the offsets and widths and ended up ditching them a few weeks later when my coilovers didnt fit
    • I always drive with the tire pressure gauges showing the PSI because I'm paranoid about getting a flat tire and not knowing then keep driving and tear it apart. No amount of goo is going to fix a shredded tire. My Q60 has the goo and the V36 had the goo too. Never used it but I have used the pump to pump up the tire to get home. Then I fixed it with a plug. Wasn't keen on the goo.
×
×
  • Create New...