Jump to content
SAU Community

Recommended Posts

Hey,

Last night when i was installing my ebc, i had the 2 inside lights on and i forgot to turn them off :D So this morning i woke up to my car alarm system going off, i ran to the car and try to unlock the door but it wasnt working, then i saw that the blue which wasnt flashing, so i unlock the door using the key and try to start the car nothing turn on :( no light nothing then i saw the 2 lights switch on the inside on.... NO!!!!

Anyway im going to try and jump start the car 2night, but i really need my car 2morrow i have an exam, can anyone requirment a place to go to get a new battery and what type? In the magla area would be the best thanks

Mike

Link to comment
https://www.sau.com.au/forums/topic/43657-my-battery-went-flat/
Share on other sites

1 hint, dont jumpstart the car from the battery in the boot.... :(

there is points there are marked out in the engine bay with the fuses and stuff :D

Hey,

Last night when i was installing my ebc, i had the 2 inside lights on and i forgot to turn them off :( So this morning i woke up to my car alarm system going off, i ran to the car and try to unlock the door but it wasnt working, then i saw that the blue which wasnt flashing, so i unlock the door using the key and try to start the car nothing turn on :( no light nothing then i saw the 2 lights switch on the inside on.... NO!!!!

Anyway im going to try and jump start the car 2night, but i really need my car 2morrow i have an exam, can anyone requirment a place to go to get a new battery and what type? In the magla area would be the best thanks

Mike

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...