Jump to content
SAU Community

Recommended Posts

Hi guys Im in need of some advise please.Went to start the stagea and the battery was flat so I charged it up and when I went to start it again it idled rough and there was no accelerator.Can some one give me an idea of what to do next as I have check the fuel filter on the pump and its clean.

Thanks

Brett

Link to comment
https://www.sau.com.au/forums/topic/438130-stag-dead-in-the-driveway/
Share on other sites

Your right Scotty , I checked the sock but I don't have a check engine light on.I ran a manual MIL check and ended up with 10 slow flashes followed by 3 sets of quick 10 flashes.The car does start but idles good for 3 seconds than idles roughly for a little while than stops.The throttle butterfly is operating.What does AFM stand for and where is it.

Thanks

Bertt

I unplugged the AFM and the car now revs but a little rough so I am about to order a new Bosch one for $80 dollars but why wasn't the engine light on,

Scotty can supply you an AFM at a better price then that. Pm him.

I unplugged the AFM and the car now revs but a little rough so I am about to order a new Bosch one for $80 dollars but why wasn't the engine light on,

Because the AFM was still outputting a signal, and the ecu though it was fine. They don't all blow in the same way, some fail and you need to unplug them to drive, others you can drive home without unplugging. Most throw the MIL though.

Contact me if you have any dramas, the replacement Nissan AFM's are crap and don't last long. Hopefully the one you got is from somewhere else.

Scotty I tried to PM you but the message is blocked.It looks like my supplier for the AFM cant supply for 3 weeks because of Chinese new year so I was wondering if you can supply me with a AFM.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...