Jump to content
SAU Community

Recommended Posts

Hi guys, my mate and i attempted to mount a tial 44mm waste gate onto my manifold today and ran into a few dramas. I bought the gate without the v-band clamps so went down to gcg turbos to get a vband. It fits on the waste gate inlet and the manifold individually but will not clamp when the surfaces are mated. It seems as if the clamp is too narrow to get around both flanges. Are there specific v-bands that suit the tial 44mm gates? Thanks

Link to comment
https://www.sau.com.au/forums/topic/439153-tial-44mm-waste-gate-v-band/
Share on other sites

Hahaha that's not a stupid question. Any help or suggestions are much appreciated (especially when im so close to getting this thing on the road). It feels pretty solid though so I'm not sure if that would work. It feels like there is a gap between the two flanges becuase of tge valve seat ring.

Try it with the new Turbosmart HP range, 45psi of spring would be a bitch.

Can you get in there with a lever? I sometimes have to put a block of wood on top of the gate and lever it with something to keep pressure on it, while someone else does up the bolt.

Try it with the new Turbosmart HP range, 45psi of spring would be a bitch.

Can you get in there with a lever? I sometimes have to put a block of wood on top of the gate and lever it with something to keep pressure on it, while someone else does up the bolt.

I might actually be able to lever it with a pry bar off the sway bar.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...