Jump to content
SAU Community

Recommended Posts

Hey guys, pod on my car is currently sitting near wheel arch... I know... I know... I bought it like that and have a pipe being made up to be able to sit it up top again. But anyway, I was driving home from work tonight, and it began to rain, I didn't go through puddles or anything remotely close to it, but the water from the rain was causing the car to drive pretty, then it also stalled out a couple of times. Could this effect my engine in anyway? as I said, the pod was at no point fully submerged in water or even close to it. But if it was sucking in the rain water, can that cause any damage to my engine.

I don't drive at all when its raining, its just tonight it decided to start raining while I was driving home from work -_- really hope I haven't caused any damage.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/
Share on other sites

My cold air intake draws from in front of the passenger's wheel. Not one drop of water goes up into the factory airbox from there. A pod hung in that location should also be fine.

A wet pod filter or wet AFM will generally cause trouble though. Did you feel the pod to see how wet it got?

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207690
Share on other sites

When I had my XR6 Turbo with pod in the guard I sucked a lot of water in one day and the car stalled. I got all the water out and let it sit over night.

I started it the next day and it ran a little rough but eventually dried up.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207699
Share on other sites

Unless you hit a big puddle and water splashes hard you wont notice any problems and even if you do and abit of wAter goes into the afm you might start to have a missfire but will go away once it dries up.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207700
Share on other sites

Yeah true. One of my friends had the same problem, but he unfortunately went through a puddle, and the whole pod was submerged in water and sucked a shitload in. Blew his engine two weeks later. So the main thing im asking is, as long as the pods not fully submerged, a little bit of water isn't going to effect the engine? I plan on fixing this asap just for peace of mind lol. The rain wasn't real hard, but it was causing the car to stall out a couple, sitting on the side of the road starting my car a couple times wasn't fun haha.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207971
Share on other sites

Is there a way of checking these things or? sorry guys, Im pretty paranoid about keeping my car healthy, going to uni atm and dont have the dollars for a new rebuild But I love my skyline too much to sell it. Would checking the oil for milky deposits be a good indication whether water has gotten that far? I know that im probably just being paranoid.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207999
Share on other sites

If you're that paranoid, just take out the cooler and let it drip into a container and check the oil that comes out of it. depending on your setup, cover the hole that the old smic has left, and make a cover for the pod blocking off the headlight etc... Put the standard airbox back in.

But really you're just being paranoid. ;) Just don't flog it when it rains, and steer away from puddles.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7208009
Share on other sites

If water was to do any damage, it would be done by now. If you car drives and runs, then its ok I'd say.

If you paranoid about driving in the rain either get a stock airbox or possible make a shield for relocate the pod...

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7208044
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I can see between the water jacket and cyl 3 there wasn't a hard line of combustion gas. It certainly appears that the issue is coming from there. Yes, checked the tension. All at 100ft lbs where I set them 5 years ago. These blocks can crack but generally when they have been over bored. Mine is only 0.5mm oversize at 89.5mm. They break between cylinders around the 91mm mark. No sign of that with mine. My gut feeling is the head gasket lifted a while back when the studs stretched and i bandaided it by retorquing the studs. It's finally let go.
    • My Nismo 1.5 churps a bit on reverse turns when cold, but besides that feels like a stock diff.
    • Yes, but, I paid cash and I'm pretty sure the receipt was in the bin 10 minutes after I got home Note to self, keep all receipts
    • Bunnings would have just handed you your money back on that one!
    • So, version 4 intake is on its way I was looking at these a while ago but at around $200 or more it was a little pricey for something that might not work, but, I had it in my watch list, but, I got a message saying it was on special, and I had a code thingie to use, it eventually came in at $120 delivered, so BAM, BUY NOW.....LOL I'll need to have a look when it arrives but I feel it will "look" better than what I currently have, as it comes with a PCV fitting, so I will be able to get rid of the alloy pipe that goes to the throttle body with the PCV fitting  Well, that's what the voices in my head are telling me  Oh, and this happened today Yeap, it was a Trojan, and it was cheap, so I headed back to the hardware store and actually spent a little bit more on a heavy duty,  one that was actually recommended by a plumber mate, a Cyclone one with a fibreglass handle that is actually rated for clay The broken shovel will eventually be "modified" into a short handle shovel
×
×
  • Create New...