Jump to content
SAU Community

Recommended Posts

Hey guys, pod on my car is currently sitting near wheel arch... I know... I know... I bought it like that and have a pipe being made up to be able to sit it up top again. But anyway, I was driving home from work tonight, and it began to rain, I didn't go through puddles or anything remotely close to it, but the water from the rain was causing the car to drive pretty, then it also stalled out a couple of times. Could this effect my engine in anyway? as I said, the pod was at no point fully submerged in water or even close to it. But if it was sucking in the rain water, can that cause any damage to my engine.

I don't drive at all when its raining, its just tonight it decided to start raining while I was driving home from work -_- really hope I haven't caused any damage.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/
Share on other sites

My cold air intake draws from in front of the passenger's wheel. Not one drop of water goes up into the factory airbox from there. A pod hung in that location should also be fine.

A wet pod filter or wet AFM will generally cause trouble though. Did you feel the pod to see how wet it got?

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207690
Share on other sites

When I had my XR6 Turbo with pod in the guard I sucked a lot of water in one day and the car stalled. I got all the water out and let it sit over night.

I started it the next day and it ran a little rough but eventually dried up.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207699
Share on other sites

Unless you hit a big puddle and water splashes hard you wont notice any problems and even if you do and abit of wAter goes into the afm you might start to have a missfire but will go away once it dries up.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207700
Share on other sites

Yeah true. One of my friends had the same problem, but he unfortunately went through a puddle, and the whole pod was submerged in water and sucked a shitload in. Blew his engine two weeks later. So the main thing im asking is, as long as the pods not fully submerged, a little bit of water isn't going to effect the engine? I plan on fixing this asap just for peace of mind lol. The rain wasn't real hard, but it was causing the car to stall out a couple, sitting on the side of the road starting my car a couple times wasn't fun haha.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207971
Share on other sites

Is there a way of checking these things or? sorry guys, Im pretty paranoid about keeping my car healthy, going to uni atm and dont have the dollars for a new rebuild But I love my skyline too much to sell it. Would checking the oil for milky deposits be a good indication whether water has gotten that far? I know that im probably just being paranoid.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207999
Share on other sites

If you're that paranoid, just take out the cooler and let it drip into a container and check the oil that comes out of it. depending on your setup, cover the hole that the old smic has left, and make a cover for the pod blocking off the headlight etc... Put the standard airbox back in.

But really you're just being paranoid. ;) Just don't flog it when it rains, and steer away from puddles.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7208009
Share on other sites

If water was to do any damage, it would be done by now. If you car drives and runs, then its ok I'd say.

If you paranoid about driving in the rain either get a stock airbox or possible make a shield for relocate the pod...

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7208044
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thank you, 100% the intent. New coils were due and the 17" sixers look/feel loads better than the stock wheels. The aero options are so spot on.   Thanks for the warm welcome, all!
    • 98 r34 gtt Been rocking my latest setup and car running like never before. Have put a good 200 miles on it since all the latest changes and additions. everything is dialed in and have been driving it a bunch.   However, all a sudden last weekend as soon as I pushed throttle passed 4k and the engine stumbles, (slow or fast acceleration) hesitates and doesn’t go above 4100 or so, like a misfire. Everything else seems fine. I had a “good” set of coil packs that I removed from car when I first got it when I changed them over to new coils. I swapped out current ones for those, but no change. I also changed the plugs, no change. Seems to rev over 4 when out of gear with no load just fine no “misfire”, but as soon as its in gear with a load of any kind, it “misfires” as soon as rpm drop back below 4 k it runs perfectly, smooth, starts, restarts and drives fine as long as I keep it below 4 k while in gear. All readings look fine, no CEL   Any idea as to what could all a sudden cause an issue when pushing rpms passed 4 k?
    • When you say your cams are 272/262 is that 272in and 262ex?
    • We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
×
×
  • Create New...