Jump to content
SAU Community

Recommended Posts

R34 GTT with R34 RB26

Probably should of started this thread before the freshen up!

Fresh respray in custom grey

Viva Garage R34 R-style Side Skirts and front bumper

Blits ADR Approved bonnet

Freshly rebuilt R34 RB26DETT
HKS Gt2530's
Custom Dumps and exhaust
N1 Oil Pump with Spool Billet Gears
Tomei Type B Poncams
Driftworks / Mocal Thermostatic Oil Cooler Kit
Nismo AFM's
ID1000 Injectors
FPR2000
Aftermarket Industries Surge Tank and Holley Dominator Pump Combo
Walbro E85 Intank Pump
Blitz GTR FMIC
Power FC (for now)
Jim Berry "Full Monty" Clutch
Nismo GT PRO LSD 1.5way diff centre installed less than 5000 km's ago
HEL Braided Brake Lines

HEL ABS Delete Kit

DBA Front Disc Rotors and QFM A1RM Pads
DBA Rear Disc Rotor and Bendix Ultimate brake pads
Apexi Type R Coilovers
Defi gauge cluster (oil temp, exhaust temp, water temp and boost)
Innovate Wideband Controller
Blitz 4 stage electronic boost controller

Cartel Drag Wing
20x9.5 / 20x10.5 R35 GTR Wheels

Makes 522hp on BP98, will have e85 figures soon - tuned by Trent @ Mercury Motorsport

post-50388-0-14926900-1400058286_thumb.jpg

post-50388-0-47559500-1400058297_thumb.jpg

post-50388-0-33473300-1400058308_thumb.jpg

post-50388-0-37464700-1400058321_thumb.jpg

post-50388-0-75460500-1400058332_thumb.jpg

post-50388-0-97445400-1400058346_thumb.jpg

E85 tune should see 600hp.

Got some 18x9/18x10 flow forms on it for drift/circuit use (rears in photo below)

350z gearbox is on my to-do list, dont ask my why I just think it needs another cog

And may go down the single turbo conversion some time soon

10154312_1482726268607135_49298526705939

Edited by The WOR57

Nice car man. Have you hit up any track events yet?

Where did you get the spoiler by the way?

Car did a powercruise when it shat an oil pump - hence it came off the road for a freshen up which became full respray etc also.

Has since done one drift event, has only been tuned a fortnight or so.

Wing available here: http://www.shop.cartel-aus.com/Drift-Drag-Wing-Drift-Drag-Wing.htm

how hard was it to get the R35 rims to fit up?

Needed 25mm spacer on front, front guards are not rolled even so they poke a tiny bit - rear guards are rolled but only running 245/30 tyre so theres plenty of room to prevent scrubbing.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...