Spring On Coilover Sitting A Bit Unequal On Bottom Perch Thingy?

[Crocker34]

Couldn't find anything on the forums. At the bottom of the coil spring, one side sticks a bit more than on the other. Is it going to be a problem, or is it ok? And if it's a problem, what did I do wrong? They're JRC coilovers for an r33 gtst. Pics below

[hardsteppa]

looks fine. unless it's in danger of slipping off/over the perch, which it doesn't look to be.

[MrStabby]

Looks ok to me too. The inside of the coil should be reasonably tight on the perch at the bottom which will be L shaped in profile, so the vertical part of the L will be against the inside of the bottom coil of the spring. I'd guess a mm or two is ok, any more than that would be sus.

[sweefu]

Another vote for should be fine.
I'd be curious to know why it's sitting like that though, those could be the wrong diameter springs for your coilover.

[GTSBoy]

I don't like it, but agree it won't fall off or cause any other damage. Concur about possibility of wrong ID of spring. Are they 65mm springs on a perch intended for 60mm (or somesuch small difference)?

[Crocker34]

Thanks guys, good to know they're ok . And @GTSBoy, I'm not sure about the dimensions as these were a $700 set of coilovers that were bought on eBay to replace the stock suspension that was in awful condition hahahaha.