Jump to content
SAU Community

Recommended Posts

pulse timing is a whole map calculation however like GTSboy says it is more noticable at idle and light load due to the fact the injector is opening and closing at a slower rate therefore making the latency timing more important.....its often a struggle to get larger injectors to idle well anyway...however newer tech injectors don't seem to suffer the same issues.

pulse timing is a whole map calculation however like GTSboy says it is more noticable at idle and light load due to the fact the injector is opening and closing at a slower rate therefore making the latency timing more important.....its often a struggle to get larger injectors to idle well anyway...however newer tech injectors don't seem to suffer the same issues.

bump up the idle RPM to around 900~1000rpm and run it pig rich :D

The cheap man pays twice... As you just found out.

Any Sard injectors will have similar issues, and they get worse the larger they are.

I can get new 550cc sidefeeds to suit the 33 that will run fine, but that is the largest they can supply. For anything else you will need to fork out for genuine Nismo's, or swap to a top feed setup which work out around the same price.

I've been running sard 650s in my 93 liner for 9 years with the first round of PFC with supporting mods no probs,it's all with the tune,

I have been using a fantastic PFC tuner in Sydney, hi yavuz. :-)

Ok just gave all the suggestions a go, no luck

Didn't hydro lock the engine when I started it so that probably rules leaking O rings out

The car doesn't want to stall anymore, would go back to idle fine at traffic lights, unlike yesterday when I was playing with the latency. Idle holds steady and is actually driveable. Just down on power and feels like it's running on 5 cylinders.

I haven't had time to check if it's actually a bad injector just yet, could only confirm that it's not #1 caus it's the easiest one to get to

Btw these 540s should be the same injector series as those 650s, same shape, both twin sprays just different colour.

If it works fine on ur car it should be fine on mine, providing that there's no damaged injectors and it's set up properly

Edited by chiksluvit

I had my tuner do all the work,I do 30000 a year

hope you get it sorted.A lot of mechs put the sards

in the two hard basket but some can get it right,

where are you? I will recommend my tuner,uni group engineering in Sydney

yavuz is the genious with the PFC and what not. :-)

one thing you can do is grab a long screw driver stick it to your ear and put it on to each of the injector metal covers and listen for it ticking....if you don't hear one ticking it could be stuck... all 6 of my freshly flow tested 850's were stuck....

Thanks guys

Yeah I had both nismos and Sards in two of my old cars and felt the Sards did the job just as well. Sure it wasn't exactly as easy as the nismos but I didn't have to worry about breaking the pintle caps when putting them in

At least the Sards are probably easier to pull out now because it uses Allen key bolts, just maybe not the #5 and 6

Yeah I'm in sydney but I've always gone to Toshi to get my cars tuned, since he just lives around the corner for me

Will try the screwdriver trick thanks Badgaz!

Edited by chiksluvit

Ok here's the latest update

Tried the screw driver trick, could hear all injectors going

Pulled the plugs on #1, 2 and 6, all seems to affect the engine. Couldn't get to the plugs on 3, 4 and 5

So went back in the car and tried to adjust the latency on individual injectors, individual changes made to 2- 6 affects idle except for #1 cylinder.

I could put the latency correction to -1 and it won't make any difference, yet if I pull the plug then it will. So it seems like #1 injectors delivering fuel but not responding to latency changes

Can this happen? I thought injectors either die or alive?

PFC is brand new when a bought it a couple of mths ago, so I doubt it's the ECU

do you have a wideband? if you can get the afr's roughly right it should be driveable.... you'll need to get it to a tuner with a fcdatalogit.

Nuh I don't have a wideband

It is driveable, just lack of power and sounds like wrx, I already took it around the block a couple of times today when testing it. Lucky toshi doesn't live too far away so I can get the car to him once I replace #1 injector if it is a dud

At least if it's really #1 then I won't have to pull the rail out again, it's easy to access that injector

I'm just puzzled at how it could be possible that an injector is delivering fuel but not respond to adjustments made while others do, in both fuel % and latency

not much he can do about it now

he reckons its likely that either one of the injector's dud or ECU or coilpack is stuffed

seeing it was runnings 100% before the injectors i guess one of the injectors needs to be replaced :/

will be checking the spark plugs later

Update: as Toshi has suggested I've taken the spark plugs out and had a look at it

they were all running rich judging by the spark plugs, this is from cyl 1, the rest all pretty much looked the same

tn_gallery_27668_5717_21799.jpg

AFAIK they all still produce spark- engine drop revs when each of the injectors were unplugged, including #1

Only thing suss- cyl # 1 injector doesn't respond to changes on the PFC

Changes on every other injector affects idle

so could be the PFC, could be the injector. The PFC is only 6 mths old and injectors were also new

:/

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Well, I can recommend the partial AV system translation CD I ordered from Car Audio Workshop in NZ. Whilst it didn't address the date issue, it has conveniently translated on-screen menu items into English, and now allows the GPS-received time to be offset in hours rather than minutes, so I can display Eastern Australian time accurately ( and bump it by another hour when daylight savings starts ).
    • Yuh, if it's 45°C outside, my car is driving in it.
    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
×
×
  • Create New...