Jump to content
SAU Community

Recommended Posts

Ok now this has me truly stumped drove my cat fo work today all is fine as normal. When I just started my car I noticed the headlights wouldn't come on then all the warning lights came on no speedo rev counter cluster lights off no display in what gear I'm in and indicators not working. Sorry no cel light but. At check, abs, 4wd and hicas are all on the abs unit make a weird winding up noise about 20 seconds after start up then stops and light comes on.

So as you can expect I'm freaking out and stumped on even where to start.

Yeah starts fine just the sytoms listed. The battery was changed a couple months ago so no probs since then. Checked fuses as good as I can in the dark I don't have a torch on me tonight so the battery fuse box is hard to read. It starts headlights take a while to come on no gear display getting error code 805 clutch position circuit or 1805 brake switch. No immobiliser so it can't be that.

Stumped :'(

  On 28/08/2014 at 1:07 PM, Commsman said:

I've had the christmas lights dash before plus a few other weird things. Battery.

Was your gear selector display up and running when this happens to you mate. Mine is blank can't select gear and speed taco and dead on 0

Oh, I geddit.

It's been absolutely pissing rain down in Syd.

I bet you've got water in one of your fuse boxes. Check behind the batter, and also in the bottom of the RHS drivers footwell.

Make sure all drain holes are clean and clear, and leave the covers off for a while to dry it out.

Sorry, don't remember about the gear selector as too many years ago. Even though the battery is very new, I'd get it checked/swapped simply to rule it out.

Yeah, what Alex says above. If you've parked in torrential rain that can happen.

Edited by Commsman

It has been passing down last night and the few days prior to but driving today all was well.

I'll check fuses in foot well and battery compartment in the morning can't see anything at this time. It's to dark. I know about the fuse box in front of the battery in that compartment is there another further back behind the battery is there?

I think there is only one in there.

Front back side whatever, I can't remember! :D

But I think it's more likely the foot well one. The muck clogs the drain at the bottom of the guard.

Have a good look around, and report back.

  On 28/08/2014 at 1:37 PM, PN-Mad said:

I think there is only one in there.

Front back side whatever, I can't remember! :D

But I think it's more likely the foot well one. The muck clogs the drain at the bottom of the guard.

Have a good look around, and report back.

There is actually two fuse boxes in the battery box. Second one is kinda behind and to the side. Wheel arch side

So no luck! Checked all fuses all are good drained the battery well it was blocked up but not up to the electrics checked footwell fuses all are good aswell. Checked battery that's goid. So guess nissan or auto electrician is next!? :-S

Searched again I'm getting error code p0805 clutch position sensor and brake switch as codes brake switch would be due to brake cut mod. Anyone know anything about clutch position sensor?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah agreed, you can't assume that shop are they only people who ever had to work on it. It was just a guess on the mods based on how things were done back then. You can check the Air Flow Meters by the part number on their tags, they are likely either Z32 or Nismo ones (both read about the same but the Z32 one is a little larger while nismo is stock size but supports the higher airflow like a Z32). And yes, all that would get you to 450hp / 340kw To tell what is happening with the turbos, you want a photo of the tag on the core, that will say what it was made out of  (they can retain the front and rear covers to make the plumbing easier)  
    • I'm selling my personal race car. 1992 BNR32 Skyline GT-R About eight years ago the engine developed the dreaded low oil pressure problem. I removed it and found the issue. However shortly after I moved half way across the country, moved my work shop, bought a house, got married, then moved my shop again to it's permanent location for the time being. in turn I do not have the time to race this car as it should be. In turn the engine I built for this car will end up in my street car and this car I hope finds a home with someone who can use it to it's full potential. The roll bar was built by Jason Noren Fabricaiton in Pomona California to SCCA and NASA Specs. The car used to compete in redline time attack and global time attack enthusiast class. It also has a fire suppression system.  The car is with me at my workshop in Kyle Texas, USA. Shipping it is no problem, I can personally deliver the car to the port of either Houston or Los Angeles. Any other port depending on where it is may require transport but we can always work that out.   The chassis itself is rust free, rear quarters and under fenders are free of any rust so it's a very solid foundation for anyone who wishes to move forward with it. As posted and at the asking price of $20,000 USD the car includes all of the following;   All OEM Body panels, front fenders, rear bumpers etc.  OEM Nissan Projector headlamps (Pictured N1 lamps were removed) OEM Nismo Side Skirts / Extensions OEM Rear Spats  Front & Rear Subframes are installed car is full roller Rear Subframe has Cusco Camber Arms, Whiteline HICAS Elimination Front Subframe has Whiteline tension rods and whiteline Sway bars w/ endlinks.  Buddy Club N1 Coilovers All chassis wiring and engine wiring is in tact. Attessa System is fully in tact and was functional before engine removal.  BCNR33 GT-R Brembo Brakes F+R with Endless MX72 Plus Pads, DBA Rotors & Stainless Steel Brake lines Billion Racing Radiator Billion Radiator Hoses Fluidyne Engine Oil Cooler Accusump System (trunk Mounted) 5 Speed Transmission w/ Transfer Case F+R Prop-shafts Rear Differential With rear Axles.  Nismo Gauge Cluster Nismo Clutch + Flywheel   Essentially what is needed to make this car running and driving again is as follows: A working Engine, an ECU, and time to put it together. The price posted is or best offer as I am willing to remove some components to accommodate price to a certain extent. If any serious buyer wants full detailed pictures, videos, or any questions I'll be happy to answer them. I believe this car is priced to move quickly considering it's a rust free and very straight chassis but always open to fair negotiation.  I can be contacted via phone or email. (+19517081648) email is juan@bardabe.com   
    • So...to my (and my mechanics doing the swap) surprise...the oil pan from NEO engine does not fit 100% and needs to by modified like this: It is not a huge problem but in the future i want a "proper" oil pan. So question is...what different oil pan can i get to fit without any problems and modification? Thanks! 
    • Some more info I found.  These are the last entries Yoshikiyo Fujii made on his blog before he passed away in 2009: http://blog.livedoor.jp/fujii_dynamics/ And finally this is where the workshop was situated:  https://maps.app.goo.gl/HhTPtHzt3WVcBTiEA  
    • shit boxes, kids, and daily drivers are all welcome
×
×
  • Create New...