Jump to content
SAU Community

Recommended Posts

So i've read around but not getting a straight answer, I'm believing it's CAS but coming here for a second opinion

So occasionally the engine will "hiccup". ill be driving down the road (usually I only notice it during freeway driving) and then the engine will like die for a short period of time, (it feels like when you lift your foot off the pedal for a split second)

I think I read somewhere it was CAS but can't since find that page to read up on it.

any help / confirmation / ways to troubleshoot it? Compression is good: 142, 150, 145, 145, 150, 150. New o2 and cleaned AFM.

is running a Power FC

RB20DET 1992 SKyline r32

Thanks for the help guys!

Edited by angusis2fast4u
Link to comment
https://www.sau.com.au/forums/topic/449952-engine-occasionally-hiccups/
Share on other sites

I have splitfires, walbro 255 pump, brand new spark plugs (I forget if this issue was around before I changed them... Could that be it??) So i would hope it's not the coils or pump... Also the issue generally doesn't happen under power like usually just when im cruising along...

How did you check your CAS??

One of my old r32 did that
Checked cas, fuel pump, coilpacks etc
Ended up being dirty AFM

i had an issue like this, but it only happened about like 5000 rpm. then it started to get worse and worse like 4000rpm then above 3000rpm. to the point i could hardly drive my car. ended up being my haltech has a safety cut when it leans out to much it will cut the engine every time its to lean,
ended up being a split hose pipe from my fuel pump to the top of my tank, so the full was getting sucked up the fuel pump then not even leaving the tank squirting out the hose then back down into the tank and then back into the pump again. only letting a little bit of fuel through at a time so was causing it to hickup so to speak, maybe check that, if it gets worse and worse maybe check this. also replace your fuel filter......... cost about $10 and is easy to do! and will rule it out, peace of mind

How does a dirty throttle bofy cause a hiccup?

And a car doesn't need tuning due to new coils. ...

Sounds like the power fc miss.

Just in case you missed GTSBOY ' S post

Edited by Ben C34
  • Like 1

i am aware of that, hence the "other mods" words in there..... clearly trying to sus out and get the most information to diagnose this issue.... you annoy me.

Ok cool. Seems odd you would mention it then.

Sorry that pointing out facts annoys you. I suppose I could just let it slide and let people think they need a retune due to replacing their coils, but hey, I'm not that kind of guy.

I have splitfires, walbro 255 pump, brand new spark plugs (I forget if this issue was around before I changed them... Could that be it??) So i would hope it's not the coils or pump... Also the issue generally doesn't happen under power like usually just when im cruising along...

How did you check your CAS??

Mechanic did back in the days

It was my first car 10+ years ago

Typically to check a cas you play swap tropics with a known working one.

Perhaps there's a way to check it with an oscilloscope, but as the issues tend to be intermittent it would be difficult and unlikely picked up like that.

Typically to check a cas you play swap tropics with a known working one.

Perhaps there's a way to check it with an oscilloscope, but as the issues tend to be intermittent it would be difficult and unlikely picked up like that.

Yeah it like rarely happens like probably not even once a week, It probably only happens like once every 2 weeks

Ill look up the PowerFC miss.

Sparks were done like 600km ago

ill check out that throttle body as well

Thanks for the help ill report back when i've got an update!

The power fc "miss" generally happens coming away from a set of lights, for example. Low rpm, generally low load. Well, mine did anyway.

There is a decent discussion on here somewhere about it.

I had this problem and it was a bastard to track down in the end for me it was the AFM pins getting a dry solder joint.

There is a guide on re-soldering in the DIY section. To diagnose I used CONSULT connected to a laptop datalogging all values. As soon as it happened I pulled over and spotted which value started it, AFM voltage dropping to 0.

Hope this helps

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I mean it's a bit late to say "This won't have any tangible effect and it is not worth spending more than about three seconds on it, please just enjoy the car" But I said it anyway. Does the pod actually get any airflow in that position behind a bumper like that?
    • Hey guys - apologies for digging this up. Has this website been shutdown or is the outage temporary?
    • So, went shopping at Just Jap for things that might work for the intake  After some trial fitting there I ended up with a 3" x 45° silicone bend, a 3" x 300mm alloy straight, and a humped joiner, some minor trimming will be required to shorten some of the stuff, but nothing that is beyond my "ham fisted" skills The guy at Just Jap was most helpful as we had all sorts of joiners,  bends and stuff out trial fitting  Laying it out above the stuff in there it seems everything will fit nicely, and looking at it, it is probably the way I should have been looking at doing it from the beginning, probably..... In the end it is a front bar off job anyway to remove the original stuff behind the front bar that is taking up the required realestate needed, so maybe a Thursday or Friday job And because I'm a hopeless consumer, I grabbed some new steel wheel nuts, the current ones are a spline drive type with a "security" socket, that somehow someone keeps misplacing, the new ones are a basic black steel 17mm hex socket In other news: I just did my "final" tax return, I am now officially a old retired veteran pensioner, and I'm milking the system for all it's worth,  life is good
    • I hadn't thought about the variable power steering assist. Presumably, it will always be the same level of assist as you get in an S14. The R32/3/4 are either helliishly heavy (at low speeds) if the solenoid is not powered at all, or hellishly too light (at high speed) if it is powered all the time. I presume that it is PWM controlled on those cars. I hadn't thought about the S cars not having variable assist. ugh. What crappy plebby cars they must be!  
    • Hmm yeah that is a good point. It looks like it'll just bolt in with no real issue besides maybe the bushings being different. My other concern was that 2 pin plug that I assume is used in some way to control the rack solenoid depending on the speed signal from the ecu. The DMAX rack doesn't even have that plug though so, don't think it'll matter. Might just order the rack and see how it goes. Will update this when I figure something out
×
×
  • Create New...