Jump to content
SAU Community

Recommended Posts

Hi, I just had my stagea dyno'd with an adaptronic 440 running in tandem with the stock ECU.

I didn't have any trouble with the stock ECU while doing preliminary drives on the base map, but while on the dyno, the tachometer stopped working, the synchro, 4wd and abs lights came on.

While the tachometer has stayed totally dead, the other lights would come on when you start the car, but sometimes go away after 10 mins or so.

While the lights were on, you could feel the transfer case locking up. The wheels and drivetrain would slip and grind while turning sharply at low speed. That went away once the lights had also gone.

I checked all the fuses and found that the 7.5 amp "ECU" fuse had blown under the drivers side coin tray. I replaced it with another, which has not blown yet, however it has not solved anything.

Now the more crazy stuff. Due to the transfer case locking up, I removed the 4WD fuse and relay in the engine bay, as per the photos.

However the warning lights were still on and the transfer case still was still locked up! How is that possible? What is actually powering the attessa pump?

I am thinking I should remove the front driveshaft to avoid further damage.

post-46287-0-93486400-1418879000_thumb.jpg

post-46287-0-70258900-1418879015_thumb.jpg

By the way the only code I an pull up is code 21 - injector signal. Im not sure if thats related as I dont have injectors connected to the stock ECU, only the adaptronic.

Im not sure how to check any other codes, like gear box or attessa?

just thinking out load

can only think the adaptronic 440 is messing with the ECU signal to the gearbox ECU

gearbox cant handle the power and has gone into limp mode ?

your description of " slip and grind while turning sharply at low speed" sounds like the diff lock was engaged ( button on dash )

i have fitted a nistuned S2 ECU in my S1 and it worked the gears ONCE and then nothing , only third gear

not sure i helped but maybe it has jogged something :)

It is like having the synchro button on, with the light and the low speed clunking. However the position of the synchro button doesnt make a difference.

The auto gearbox seems to be functioning normally as far as I can tell.

Does the attessa system have its own computer and such? I remember something behind the carpet at the rear of the wagon on the passenger side. Opposite side to the reservoir tank.

Just bumping this. I have put my head in through the passenger side flap in the boot to try and see any flashes of light. I tried this with the ignition in the on position, and straight after starting, but could not see any lights.

I have read that the car needs to be driven over 30kmh for a minute to bring up error codes, even though the warning lights are on the dash as soon as the car is started. Can anyone confirm this?

Where exactly is the flashing LED? I poked around with a mirror looking for a light on the computer, but all I could find was a small hole in the computer approximately on the bottom right of the unit, if you are looking at it from inside the boot.

Edited by zoomzoom

I have an instrument cluster that is always full of petrol,runs hot, speedo does not work and only does about 400 revs. All the warning lights work fine.

Y?

Well, theres definitely no lights coming from the attesa computer in the back. I can't even see the "port" where the light would be that people have referred to (mainly on r32s though)

Tried manually bridging the 4WD relay in the engine bay to hear if anything worked. Strangely the synchro light went out!

Also, I did an ECU scan through OBD scan tech. It can only detect 3 computers: engine, auto trans and airbag.

I now have NFI how to read any codes from the attesa.

Woohoo, well a long story short, the ATTESA requires an RPM signal (along with a TPS signal, but that was functioning)

It seems both the tacho pin on the stock ECU is non-functional, and also appears as though the tacho itself is faulty.

Its hard to tell exactly where and how the wires to the tacho and ATTESA are joined, but I fixed the 4WD by splicing a new wire from the tacho pin on the ATTESA harness to one of the aux outputs on the adaptronic which I configured as a tacho signal in WARI. The warning lights cleared straight after starting the car, and I could hear the pump priming. Such a beautiful sight.

Tach is still dead, ironically it will probably be more of a problem then the 4wd...

Edited by zoomzoom

I figure that will be the case, but I think my ECU is still faulty too. I dont think the piggyback ECU is going anywhere, maybe its time for a mad 1990's "futuristic" digital dash? Im not sure why they didn't catch on.

  • 2 months later...

Just reread your first post. It takes more than pulling the awd fuses to disengage the attessa. Were you on a 2wd or 4wd dyno?

For what its worth here is the manual on turning the Attessa off (sorry forgot I can't paste to this forum for some reason so I'll try to attach it)....

4wd to 2wd text.txt

Its all good now. The car was on a 4wd dyno, I only had a chance to diagnose what the 4wd was doing once I drove it on the road. Pulling out the fuses did disable the 4wd though? If theres no pump pressure, there should be no torque applied to the front wheels beyond the preload on the transfer case?

Anyhow, I was mainly sharing the tacho fix, I know theres a few people who have busted tachos.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to it's full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so damn hot in there, that made it all the more easy to remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. I was standing there looking at the car and said 'f**k it'. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...