Jump to content
SAU Community

Help :p

davidnsw

By davidnsw,
in Four Door Family & Wagoneers

 Share

Recommended Posts

davidnsw Contributor

davidnsw

Posted
Posted

So of course my stagea has to give me the shits while my other car is getting work done >.<

driving home today stopped at a light and when i took off again the car went about 10m then lost all revs so i pulled over, i have gathered its gone into limp mode and narrowed it down to a dead MAF!

The big question does anyone know where i can get a replacement in the northern suburbs melbourne? any help greatly appreciated.

Dave

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/
Share on other sites
Cowboy1600 Grand Master

Cowboy1600

Posted
Posted

So of course my stagea has to give me the shits while my other car is getting work done >.<

driving home today stopped at a light and when i took off again the car went about 10m then lost all revs so i pulled over, i have gathered its gone into limp mode and narrowed it down to a dead MAF!

The big question does anyone know where i can get a replacement in the northern suburbs melbourne? any help greatly appreciated.

Dave

What car do you have?

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7573083
Share on other sites
scotty nm35 Grand Master

scotty nm35

Posted
Posted

I used to sell them but ran out of stock. Try the part number in Ebay, there are heaps of aftermarket ones available that won't bugger up like the Nissan ones commonly do.

I am trying to find the reason the AFM faults, it's likely caused by low voltage I suspect. Have you popped the bung out of the battery compartment by any chance? That's where I would start. The large 2 inch bung gets blocked flooding the relay box causing all sorts of issues. Not sure if the AFM is related to this as yet, but it looks like it may be, at least you will have fixed a source of many other electrically related failures.

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7573089
Share on other sites
KiwiRS4T Grand Master

KiwiRS4T

Posted
Posted

What's your factory part number? It may well fit but they don't know so they say it doesn't to cover themselves.

Here's another one I found - does the factory number it quotes match yours?

http://www.trademe.co.nz/motors/car-parts-accessories/nissan/other/auction-920614276.htm

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7573170
Share on other sites
YangLIU Rising Star

YangLIU

Posted
Posted

I used to sell them but ran out of stock. Try the part number in Ebay, there are heaps of aftermarket ones available that won't bugger up like the Nissan ones commonly do.

I am trying to find the reason the AFM faults, it's likely caused by low voltage I suspect. Have you popped the bung out of the battery compartment by any chance? That's where I would start. The large 2 inch bung gets blocked flooding the relay box causing all sorts of issues. Not sure if the AFM is related to this as yet, but it looks like it may be, at least you will have fixed a source of many other electrically related failures.

Maybe the high voltage? I saw the voltage reach over 5v if run in height boost.

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7573204
Share on other sites
YangLIU Rising Star

YangLIU

Posted
Posted

the part number on the one i linked matches but that trademe one is different. I found one on ebay just before that someone else used in an m35 so ordered it :) hopefully it works

I bought 2 from eBay but all shit! One is dead after ran 10km. another one is still alive but the voltage is not same as stock one...so I can't use it. Finally I bought genuine one from Nissan with bloody price...so far so good for about 1000km

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7573207
Share on other sites
scotty nm35 Grand Master

scotty nm35

Posted
Posted

Sorry to hear Yang, it did take me a while to find a suitable supplier for the aftermarket AFM's I used to sell. Amayama would have been a better option for genuine, but the shipping times from UAE aren't as good as the local Nissan dealership.

Maybe the high voltage? I saw the voltage reach over 5v if run in height boost.

You are looking at the output voltage, not the input which is 12v. The AFM's have a processor inside which would likely fault if the voltage dropped too much, and the water in the battery compartment would be the obvious cause. A lot of us have had AFM's fail after or during rain too. Not saying it's definitely the cause of AFM issues, but it most certainly creates many other electrical issues. Pop that bung out before it leaves you stranded, it serves no purpose other than to keep dust out of there.

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7573222
Share on other sites
blackaxis Rookie

blackaxis

Posted
Posted

Mines been playing up and im about to grab a new one. If after genuine amayama have australian stock 22680-6n21a for $110 + postage.. if you look up the original number the price is 5x that for some reason.. the replacement number above looks to have been used by people on here with sucess by searching the forum. if in more of a rush justjap have genuine stock for a few dollars more but still cheaper than half of the ones on fleabay...

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7573364
Share on other sites
  • 3 weeks later...
davidnsw Contributor

davidnsw

Posted
  • Author
Posted (edited)

well 2 weeks and its gone again... was a justjap one, in a bit of a bind now as i just totalled my other car >.< anyone know of any that aren't from Nissan in stock in Melbourne today or tomorrow?

much appreciated. if anyone can help pm me and i will get back to you straight away.

Dave

Edited by davidnsw
Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7586681
Share on other sites
scotty nm35 Grand Master

scotty nm35

Posted
Posted

Not really, the new Nissan PN just fails constantly, some of my customers went through 7 or more before fitting my aftermarket ones. Mine were lasting fine.

The original PN works very well, 15 years nearly in my case.

Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7587393
Share on other sites
YangLIU Rising Star

YangLIU

Posted
Posted (edited)

Not really, the new Nissan PN just fails constantly, some of my customers went through 7 or more before fitting my aftermarket ones. Mine were lasting fine.

The original PN works very well, 15 years nearly in my case.

why don't you sell your AFM again....LOL

my brand new genuine one lasts for 2month now. and I have 2 genuine AFMs with old PN in glove box....

Edited by YangLIU
Link to comment
https://www.sau.com.au/forums/topic/458459-help-p/#findComment-7587454
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Songo
      New kid on the block

      By Songo · Posted

      Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • MBS206
      New kid on the block

      By MBS206 · Posted

      https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Cangorus
      New here

      By Cangorus · Posted

      Hello everyone, I am happy to join you.
    • Duncan
      New here

      By Duncan · Posted

      Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...