Jump to content
SAU Community

Recommended Posts

I've organised a drift day with NS.com and thought a few SAU members may be interested in attending. For the first drift day we will be having publicity and request intermediate or advance drifters for the first event, and subsequent events will be open to all..... If this first one goes well I'll organise an SAU drift day in the very near future...

XTC & NS.COM Morewell Drift Day

The details have been finalised.

WHERE: Morewell Hill Climb Circuit

WHEN: 21st August 2004, 9:00 am till 6:00 pm

COST: $75 Track Fee, $25 Annual Membership

Morwell is located about two hours out of Melbourne. The event will recieve full coverage in magazine (most likely Drift Battle), and probably TV also. The track will be available for the whole day with ambulance and marshals present for safety. Numbers will be strictly limited to ensure maximum track time. Gold Coin Donation entry for all spectators. All profits will be donated to the Track.

There will be a drivers briefing at 10am and is ESSENTIAL for all drivers, if you miss it you don't drive.

Remeber:

1. Two hours drive down and back

2. Can transport all their own spare rims and tires (no fitting available)

3. $50 Deposit required to confirm place

4. Can drift reasonably well as the first event will be getting massive exposure

Please e-mail, call me on 0425 818 755, or drop in at XTC to arrange payments.

Doc.

Link to comment
https://www.sau.com.au/forums/topic/45921-xtc-drift-day-morwell-invite-to-sau/
Share on other sites

  • 2 weeks later...

is it really essential to be half decent? :( i wouldnt mind bring the ceffy as i should have it on the rd by then... but if ur going to hold another one when would it be? i'll go along to a couple of calder prac events before the next one :)

"if it gets there??" thought the innards were fine man, did you find somthing in there?

Nah, getting some headwork done, and also ordered my flared guards to fit my 17x8's all round :)

  • 4 weeks later...

I must confess I did scratch one of those horrid Zelda Tri Spoke when I had it, but never did infact bent it at all ...

.... sniffs.... i miss that car when it was straight :D



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...