Jump to content
SAU Community

Recommended Posts

You could try wrecking yards around your area. I haven't got one to sell you but what kind of spoiler are you looking for? The low profile ducktail spoiler or the R34 coupe spoiler?

IMG_6069.jpg

maxresdefault.jpg

If it's the latter then any 2 or 4 door GTT's spoiler, in addition to the GT spoiler, would fit.

Edited by Wordsmith
  • 3 weeks later...

hey burger whats the quality of there stuff like? been searching for a reasonable knock off GTR wing for a while and they look pretty decent.

sorry to hijack your thread.

hey Pearcey I have a knock off GTR wing and it's same as real one even pulls apart the same there pretty good got mine from a body shop in QLD pretty happy as I could fined a real GTR one :) Edited by DanMac34
  • Like 1

Oh that sounds awesome, most i've seen online look very average. Would you happen to have details of said body shop? :rolleyes:

post-141096-14538790512066_thumb.jpg

It coast me $400 including shipping

55 Moss St, Slacks Creek.QLD 4127

Phone: (07) 32901148

[email protected]

A&J Autostyle

It's just not called gtr wing cause it's a copy

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi. This is just my curiosity because iam sure the tuner figure something out...but either way i want to ask. The "problem" is that the Nistune ECU (Stagea FW and RB25DET NEO from Stagea) sees many times the speed than the speedo does(he says the speedo show 120 km/h - correct speed and the ECU shows like 510km/h ) I told him that this car/tranny getting speed from rear diff. If iam not mistaken the RB25DET NEO "need" to see tranny speed sensor? (my tranny has the plug for it). So couple of "question" If he connects/wire the speed sensor to the tranny...are the signals gonna intervene and if...what if he disconnects the rear diff one and the speedo stops working? Or the "new" sensor from the tranny "take over" and will not going need the one from diff? As i said i know he figure/get that done...iam just curious to know what are the solutions 🙂 
    • Your IACV is set to idle too low. You need to adjust it via the screw Duncan mentioned. From memory it should be 650rpm with the valve electrics unplugged. What is it trying to idle at with the IACV plugged in?
    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
×
×
  • Create New...