Jump to content
SAU Community

Recommended Posts

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Been up to the cross a few times, good views on a clear day. Most times found it crowded with tour buses and the restaurant there seem to be a little overpriced for not much chop. I also don't recall any barbies or anything.

However, what about a meet up, there or Macedon township or somewhere else. Then drive over the mountain and take the back way into Hanging Rock and stop for a...ummm...picnic.

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7687784
Share on other sites

Did someone say Picnic....at Hanging rock...ummmm. Sounds familiar :)

Sunday 13th March is Labour Day Weekend.

If we can get some idea of numbers then we can arrange a few meeting points and route.

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7687996
Share on other sites

Since this is out in the west i'll be up for whatever happens. Also checked out Hanging Rock website and they charge 10 bucks per car entry. It's been 25 years since i was last there all they had then was some barbies, dunnies, a racetrack, oh yeah and a big rock.

As i said, March is a little tricky, I've penciled in the 13th, so I'm keen.

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7688890
Share on other sites

I'm definitely up for a cruise. Haven't been able to make many meets. I'm down for whatever, except march 13th LOL :-P

The following Sunday, the 20th, is the Melbourne Grand Prix.

I assume a few will be going or watching from home so the cruise turnout would not be so good.

Can we have a show of hands for the 13th vs say 27th?

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7692683
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...