Jump to content
SAU Community

Sick of killing stock injectors for NO GOOD REASON. Details inside and please recommend a drop in replacement that wont break.


Recommended Posts

You stated in your original post how the car was running great for a period of 10 months until you added the remainder of the e85 treatment. I still cant comprehend why anyone would add that additive to a car thats not tuned on e85 even if it doesn't have a warning label stating not to use on unleaded cars. Why didnt you just buy the nulon unleaded fuel treatment? It's almost like running diesel fuel in an unleaded car (probably a bit of an extreme example but you get the idea). 

Yes, I think, despite apparent clear link to the fuel treatment, the electrical death of injectors cannot be attributed to the liquid flowing inside them.  The common cause of killing multiple sets of injectors on the same car has to be on the electrical side.

  • Like 1

Mine is an S2 so no dropping resistor on the back of the coil cover .

I would think that electrical issues are a definite possibility here . Can you check that resistor or find some mod to remove it from the equation ?

Just a thought cheers A .

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Steam valve seals are usually responsible for cold start smoke, it goes away once engine warmed up. Disconnect it let engine breathers and let it breath freely, see if problem goes away after a short drive. Also check to make sure engine oil drain pipe is not blocked or kinked. 
    • Haha thanks! Yea I'm moving over from 2x 1000cc jets pre throttle over to 6x 190cc direct port jets and 1x 500cc pre throttle jet.  Direct port comes with all the advantages you would expect, except that pre throttle does cool down IAT'S more. That's why my direct port nozzle placement is closest to the plenum as possible in the runners to allow the air more time to cool before being sucked in. I'm also putting that one 500cc pre throttle jet to help with more cooling. It's a hybrid system. There's a lot more advantages to moving over to a PWM solenoid with a constant pressure system vs my old PWM pump setup, but I'll get more into that once I'm done converting everything over. The ricer in me is excited to see SS tubing all over my manifold though!
    • Very cool, see what I did there? 🥲 Wild WMI setup, first I've seen where it's on each cylinder runner, usually I see a single jet pre throttle.
    • Welcome mate. What type of work were you looking at getting done? Majorly of decent skyline workshops are in the SE.
    • Thanks mate, haha that's it ey, no more boosters and what not, should make for a good time
×
×
  • Create New...