Jump to content
SAU Community

Recommended Posts

thanks for all the response guys....awesome..i still havent worked out if BCNR33 GTR seats will fit into my BNR32 GTR though.

Amaru, thanks for checking, cant wait to check back and see. Could you perhaps PM me the details or perhpas a picture of how it looks? I would just like to see how much different it fits size wise and also trim difference to the rear seats when actually installed in the car.

TG

Will Fit 100% No Probs, GTS/GTR/32/33 seats all interchangable

I have 33GTR seats in my 32GTSt, a mate has 32GTR seats in his 33GTS25T, has also had a 32GTSt drivers seat in his 33GTS25T at some stage as well, they all bolt in no probs

Chris

BNR32: The seats are physically the same size from what I can tell, and the "outer" material is the same color. The only difference is the insert in the middle of the backrest and part you sit on, whereas the R32 seats is all "flush", the R33 seat has lines through it. It doesnt look out of place unless you look at it closely, and even then it doesnt look stupid/mismatched (well not a whole lot).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
×
×
  • Create New...