Jump to content
SAU Community

Recommended Posts

Ive just bought a r33 rb25de that was sitting for 5 years. Did simple service by changing the fluids, filters, spark plugs and coolant temp sensor. Sadly the car misfires badly, idles badly (sounds like its going to stall) and over heats. The over heating is probably due to the broken water pump.

Ive done a bunch of research and it seems like there is a ton of variables that could cause my problems. I was wondering where would be the best place to start to help fix my problems?

Link to comment
https://www.sau.com.au/forums/topic/480176-r33-rb5de-misfire-and-bad-idle/
Share on other sites

Did you drain the fuel tank and change the fuel filter?

Check the coils for shorting and then either clean and insulate them or replace them (and try gapping the plugs down to .63)

When you replace the water pump do the cambelt etc.

Not sure exactly what you mean by broken water pump, but if coolant is not flowing properly you need to start there

Also, if it has been sitting 5 years everything in the fuel system is a problem. Definitely need to flush the tank and replace the filter like Bob said, but it is likely fuel pressure regulator, lines and even injectors will be gummed and failed. I'd replace all lines, FPR and have injectors flow tested before trying much more.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi...a bit a "development" on the brakes. I spoke to the guys where i get brakes from...and they are saying that 296mm EBC are for R34 GT-T. I then went to their site: https://www.ebcbrakes.com/vehicle/uk-row/NISSAN/Skyline (R34)/ and search for my car(R34 GT 1998 - it has GTT brakes) and it show me this USR1229 number and they are rly 296mm rotors... So now iam rly confused... The rotors i have now on the car are 310mm asi shown... So where is the problem? Does the whole EBC got it wrong or my calipers are just...idk know what?  
    • Oh What the hell, I used to get a "are you sure you want to reply, this thread is XX months old" message. Maybe a software update remove that. My bad.
    • This is a recipe for disaster* Note: Disaster is relative. The thing that often gets lost in threads like this is what is considered acceptable poke and compromise between what one person considers 'good' looks and what someone else does. The quoted specs would sit absurdly outside the guards with the spacers mentioned and need  REALLY thin tyres and a LOT of camber AND rolling the guards to fit. Some people love this. Some people consider this a ruined car. One thing is for certain though, rolling the guards is pretty much mandatory for any 'good' fitment (of either variety). It is often the difference between any fitment remotely close to the guards. "Not to mention the rears were like a mm from hitting the coilovers." I have a question though - This spec is VERY close to what I was planning to buy relative to the inboard suspension - I have an offset measuring tool on the way to confirm it. When you say "like a mm" do you mean literally 1mm? Or 2mm? Cause that's enough clearance for me in the rear :p I actually found the more limiting factor ISNT the coilover but the actual suspension arms. Did you take a look at how close those were?
    • @GTSBoy yeah sorry i know thery are known for colors bud those DBA are too in colors 🙂 Green will be good enough for me  
    • That's my life. Past-Duncan has a lot to answer for
×
×
  • Create New...