Jump to content
SAU Community

Should i go this colour?

Guest two.06l

By Guest two.06l,
in General Automotive Discussion

 Share

Recommended Posts

Guest two.06l

Guest two.06l

Posted
Posted

about to put new paint on the "Stace Racer". Was going to go with the factory colour until i saw this R34 GTR colour. Keep in mind i am using Nismo LM GT-4 rims in bronze and going the clear indicator look. Does anybody know what it is called, and what the paint code is. Thanks in advance.9881137-3715_IMG-med.jpg

Link to comment
https://www.sau.com.au/forums/topic/57301-should-i-go-this-colour/
Share on other sites
BoOsTeD_RB26 Experienced

BoOsTeD_RB26

Posted
Posted

Just be a little careful of the colour codes given out on the forums. I wouldnt want to go spending bulk money to get it sprayed, and then ending up not being the right colour :)

Maybe PM one of the guys on Skylines Down Under? Or the Pro Spec website?

A few of the people on those forums/sites have the NUR edition cars in that colour. I'm sure theyd be able to give you the code directly off the plate.

Best of luck...

Blitz Grand Master

Blitz

Posted
Posted
Just be a little careful of the colour codes given out on the forums. I wouldnt want to go spending bulk money to get it sprayed, and then ending up not being the right colour :)

Maybe PM one of the guys on Skylines Down Under? Or the Pro Spec website?

A few of the people on those forums/sites have the NUR edition cars in that colour. I'm sure theyd be able to give you the code directly off the plate.

Best of luck...

Which is why any good panel shop would do a test to check the colour is correct before spraying the car

Guest two.06l

Guest two.06l

Posted
Posted
Which is why any good panel shop would do a test to check the colour is correct before spraying the car

Yeah Blitz, nothing like using a bit of good ol common sence is there. I would have just got the whole car sprayed and checked the colour when they were finished. lol...

NXTIME Grand Master

NXTIME

Posted
Posted

These are some colour codes that I have found durin a brief search:

KV2 - Silver

WV2 - Pewtar

GV1 - Black

QM1 - White

QX1 - Pearl White (3 layered pearl)

EV1 - Yellow

AR2 - Red

LC2 - Midnight Purple

Can't guarantee accuracy though :)

Guest two.06l

Guest two.06l

Posted
Posted
These are some colour codes that I have found durin a brief search:

KV2 - Silver  

WV2 - Pewtar  

GV1 - Black  

QM1 - White  

QX1 - Pearl White (3 layered pearl)

EV1 - Yellow  

AR2 - Red  

LC2 - Midnight Purple

Can't guarantee accuracy though :)

thank you nx, hows the car going. Sounds like a bit of a weapon.

NXTIME Grand Master

NXTIME

Posted
Posted

No probs. I am still looking for the code for the blue/purple R34 colour. Don't even know the name. Car isn't going yet, but I will be paying it a visit tomorrow and will get an update on it then. Weapon? I hope so :)

sewid Grand Master

sewid

Posted
Posted
No probs. I am still looking for the code for the blue/purple R34 colour. Don't even know the name. Car isn't going yet, but I will be paying it a visit tomorrow and will get an update on it then. Weapon? I hope so :rofl:

The R34 blue is called Bayside Blue (TV2) and the purple is Midnight Purple III (LV4).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Rear subframe stay bracket bolt removal issues

      By GTSBoy · Posted

      Grind them off, drill them out. Repair any rust on the other side. Start again from scratch.
    • Iron Mike
      R34 GTR parts garage clean out

      By Iron Mike · Posted

      Big R34 GTR parts cleanout. I have a lot of stuff collected over the last 14 years and my missus is giving me hard time. Make my life easy.   Nismo GT carbon fibre diffuser fins (discontinued)  NEW  $2900 Garage Defend Stingray canards carbon fibre  NEW  $1300  Top Secret G Force carbon fibre front diffuser  NEW  $2000  Haltech Elite 2500  NEW  $2500  Haltech Platinum Pro R34 GTR   USED  $1400  Apex’I power FC D'jetro + hand controller R34 GTR   USED  $1400  Nissan OEM BNR34 ECU  USED   $1000  HKS EVC 6  USED  $600  Blitz dual SBC ID boost controller.  USED  $350  TRE 255 LPH Fuel pump  NEW  $100  Fujitsubo  Super Ti exhaust  USED  $2700  Tomei Expreme Ti exhaust  USED  $2000  Trust stainless steel front pipe  USED  $1000  Apex’I super suction kit  USED $400  BC BR coilovers  USED  $600  Hardrace front upper camber kit. USED  $300  Garret 2860-5 turbos –  one good, one needs reco USED  $1000  Nissan OEM Toshiba MFD Screen replacement  NEW  $450  Nissan OEM BNR34 Series II front passenger seat  USED (mint) $5000   Nissan OEM BNR34 front bar in TV2  USED  $1000  Nissan OEM BNR34 front lower air spoiler  USED  $900  Nissan OEM BNR34 front lower air spoiler (painted)  USED  $900  Nismo front indicator (clear) USED  $80 Nissan OEM BNR34 radiator  USED $500  Nissan OEM BNR34 turbos  USED  $500  Nissan OEM BNR34 intercooler USED  $800  Nissan OEM BNR34 front swaybar   USED  $500  Nissan OEM BNR34 intake pipes   USED  $400    Also have a square set of uber rare Volk CE28n in 19*10 +22. Not really keen to sell these but make a high enough offer and maybe I will. If you don't know how much these usually sell for don't bother.   PM for pics.  Pickup Chadstone VIC or postage at buyer's expense.
    • waxracing
      Power steering pump r32

      By waxracing · Posted

      Thanks Mate, I did know you could do that but i know there is a pump out there that you can bolt on and it all lines up. I was told about it and then forgot the model, I figure if i am pulling it apart i will just put a new one on 
    • TurboTapin
      Power steering pump r32

      By TurboTapin · Posted

      You can also remove the veins from the HICAS portion of your existing pump. 
    • DatsunBanana
      Rear subframe stay bracket bolt removal issues

      By DatsunBanana · Posted

      Trying to swap the rear subframe on my R34 and can't remove the L-shaped stay brackets between the front subframe mounts and the sill/chassis. I'm in the UK so rust is a problem. I've used loads of WD40 and then Tunap 103 for days beforehand. I backed off the bolts forward a bit, backward a bit repeatedly for ages to try and avoid snapping. They have all moved a few full turns. The one I've spent most time on has come loose and I can turn with fingers, and it will pull down and push up 2-3mm. But it won't come out. I can tighten it back up and loosen it off again repeatedly but it still won't come out. I assumed there's a captive nut inside but if that's broken loose then I can't understand why I can always tighten the bolt back up - I'd expect it to just spin both ways. Any ideas what's happening here? I can't visualise what's inside there to cause this.
×
×
  • Create New...