Jump to content
SAU Community

Recommended Posts

hey guys.

I was just wondering what would be needed to do the conversion to rb26 as im looking into doing it after the new year.

- is the gear box connection the same?

- engine mounting/connection are the same as rb25?

- what will be done with the drive shafts if the rb26?

and how much would this conversion cost if i was to do it my self?

Thanks in advance :)

:)

Link to comment
https://www.sau.com.au/forums/topic/58728-rb26-into-r33-gts25t/
Share on other sites

Doing it yourself... no more than 6k tops if you do it yourself as you say

it would be far from 10k.

Then you sell your old motor/loom you rip out

All you need is the Complete Motor with loom & ECU.

And you'll need a set of dump pipes (if you dont get em) and then just match to your existing exhaust

You could certainly get it done for less than 6k without a doubt if you sell your old motor too

Just change all the belts and stuff before you put it in.

The gearbox you have in your R33 will be fine, so driveshafts and stuff certainly dont need changing. Engine i beleive bolts up to exisiting mounts. The Joy of Nissan RB's, pretty much interchangeable

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...