Jump to content
SAU Community

Recommended Posts

Fellas,

Yesterday was quite hot in melbourne and my engine temp reached 86c which is warmish but the car still ran fine... Today when i went to drive my car the idle is very irratic. when the engine is at operating tempreture the engines idle goes from around 900-1400rpm by itself... Constantly goes up and down. I have checked most of the electrical connections and most of my hose connections and yet and still have no cure....

Any help would be much appreciated

i have a 96 mdl r33 turbo manual with a Power FC computer

Cheers

Link to comment
https://www.sau.com.au/forums/topic/59049-idle-is-up-to-shit-help/
Share on other sites

Hey mate,

Not sure whether i completely understand your problem, but it sounds like a similar problem I had... I suggest you check the harness running in2 the ECU, because that was my problem...

The RPM signal was cut, and re-soldered but a very average effort so when it got warm the wire's would expand then when it cooled it would only contact every so often so it would be unstable.

The wire colour is yellow with a blue strip running through it...

Hope this helps but not too sure because I'm not sure whether the harness was changed with the Apexi FC...

Goodluck mate,

Let me know how you go!

the problem seems to be related to engine temp... car idles fast when its cold because its on the cold start procedure, when the engine temp gets to 60c the engine note changes a little and as soon as it hits 68c the idle goes all funny.... from 1200-1600rpm.... up and down up and down constantly.... When I turn the car off and restart it straight away at operating tempreture the engine sits on 2000rpm for around 5 seconds and the drops to 1200rpm and revs up to 1600rpm up and down.... Its really giving me the sits...

It didnt do it yesterday but today i did.... Very very strange

Make sure that you have a fully functioning genuine Nissan Thermostat.

Rated at 76.5degC (stamped on it) $30 from Nissan if thats the problem.

The thermostat is designed to commence opening at 76.5degC and be fully open at approx 90degC.

So yeah, the temp should be within this mark when at operating temperature.

Also with age the Clutch Fan can be engadged all the time, and not allowing the motor to warm up properly.

The clutch centre is viscous type, and should only tighten up when its warm.

And the last thing, make sure the guage is right that you have the temp reading from.

Does it use an independant sensor or is it piggybacked to the factory sensor?

If its piggybacked you can get wrong readings.

I would consider 86-92degC normal operating temp for these motors.

86 cruising

92 idle with air-con on + hot day.

If its way lower than that, you are going to get bad economy and accelerated engine wear.

Is that for a RB25det only? because my R32 RB20det sits on 78degC for normal driving and the highest ever temp was 86degC in stinking hot heat with a full car load.

Thats a general rule of thumb for most motors.

78degC sounds preety fine to me.

I mean if it were lower than the thermastat temperature then it would be a problem.

i.e If you said it was running at 50degC all the time, then there would be a problem.

  • 3 weeks later...
Try cleaning the AAC valve. Check the TPS throttle-closed position.

sorry to dig up the thread again but I have been having issues with idle lately also.

Each time I disengage a gear and return to neutral, ie when stopping my revs seem to jump up a couple of hundred rpm. I have pulled apart and cleaned out the AAC Valve numerous times in the last 12 months so it must be something else, any ideas?

Where should the TPS position be when closed? Is there a general rule like TDC or something?

Thanks

Dale

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...