Jump to content
SAU Community

Recommended Posts

  • Replies 116
  • Created
  • Last Reply

Top Posters In This Topic

ok I would like to know about the date taht you need payment by and when you expect to have these products. And if the piping goes back to standard piping on the passengers side of the car?

might be interested in large fmic and piping, thats if piping goes to stock pipes and you have both at the same time and if i can pay when i pick up. As I don't believe in cards or netbanking.

As I said these kits are suppose to be the same as the hybrid kits. So here is the link to the hybrid intruction manual for fitting the cooler and kit.

http://www.hybrid-power.com/installation/GTS%20kit.pdf

If your seriouly interested please let me know.

just wondering if we got all the brackets and bolts for this piping kit.. as i got the cooler from you.. and just need the piping kit now.. would i need to make up own brackets or are they in the piping kit..

please say they in the piping kit save me alot of time hehe

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...