Jump to content
SAU Community

Recommended Posts

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

NOS on turbo cars is the best antilag you can get but setup in 2 stages,Less gas as boost rises. Ive used it on turbo automatic cars to aid launching on low stall converters.

Anyone seen the green ZD fairlane (1971) that got banned a few street meets ago?250rwhp then hit the gas and it finds 490rwhp and run 10s on basic old suspension.

You could lift an n/a RB25 to close to 300rwhp if setup right as we have even done this in crappy red motor holdens so an RB has to be able to. We ran Tango1 with NOS last year on cheap cast pistons.

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/page/2/#findComment-1152957
Share on other sites

Mirkz , as some of the guys have said , a propper NOS system is fully independant of any ecu . It's just a matter of jetting the fuel nozzle to suit the Nos nozzle your using & keeping the pressure up in the nos bottle (Bottle warmer :))

50 to 100rwhp gain on your stock gutted 25 should be readilly achievable.

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/page/2/#findComment-1153382
Share on other sites

Guest
This topic is now closed to further replies.



  • Latest Posts

    • ouch! how is the car now?I had sold my gtr but have been looking into some on trademe and a 260RS but I wouldnt be keen on any repairs needed on them
    • This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
×
×
  • Create New...