Jump to content
SAU Community

Recommended Posts

Hi guys

Im contemplating throwing nos into my car cause i can get a real good deal on any HP shot (full system) OZ NOS setup?

MY rb25det, is pretty stock @ the moment (internals) other than 3" turbo back, fmic, ems, 550cc injectors, fuek pump etc...

What HP do you guys recommend, & if so, what should i have done to the motor to not fry itself...???

& I wont be using it much @ all, only on the track once or 3 times etc...

Link to comment
https://www.sau.com.au/forums/topic/62812-nos-system-wetdry-for-rb25det/
Share on other sites

Single fogger wet system, running a 50 shot I think or a 75 hahaha one or the other, be careful though the oz nos system looks like good value but when a NOS brand single fogger wet system is only $850 now with a 10lb bottle its hard to go past as the oz nos comes with no bottle

Brett

Single fogger wet system, running a 50 shot I think or a 75 hahaha one or the other, be careful though the oz nos system looks like good value but when a NOS brand single fogger wet system is only $850 now with a 10lb bottle its hard to go past as the oz nos comes with no bottle

Brett

say i buy the real "NOS holley" setup , with everything....is it still cool to hook it up & use it only once every while? like @ drags etc.,.

& being in nsw, can i cruise around & not get done by cops as long as i dont have the bottle in the car yea?

Mate its the single fogger wet system you need as the holley set up is for a carby, yep as long as the bottle isn't in the car you'll be fine and yep its fine to use every now and then you might just need a after market ecu to be able to take a couple of degrees of timing out if you plan on running anything bigger then a 50 shot

All testing should be done on a dyno though to check if it needs it or not

Mate its the single fogger wet system you need as the holley set up is for a carby,

Holly make systems for Fuel injected cars as well as carby systems.

you might just need a after market ecu to be able to take a couple of degrees of timing out if you plan on running anything bigger then a 50 shot

You shouldnt need an aftermarket ECU, just set the mix correctly.

Correct me if im wrong, But if your running 550cc injectors should your car have an aftermarket ecu? It would be over fuelling to the shithouse as the the stock ecu is already programmed to run rich mixtures?

Is it really that safe running NOS without Aftermarket PIstons?

Is it safe to increase boost without aftermarket pistons ?

There comes a point for any engine where enough is enough. The rb25det seems to be OK up to 250rwkw, so an extra 75hp of NOS at this point might be pushing it too far, but if you are only putting out 150-200rwkw, then a shot of NOS is probably your cheapest way to get that much power.

if you can use a diffrent brand it would be ok.

i had a faulty nos solanoid with my very first nos setup . it was a OZNOS type wetkit and the nos solonoid didnt shut so even though i had the switch of it was still throwing nos into the motor :( lucky i had a passanger that could reach the bottle and turn it off.

since then i have had two NOS BRAND kits and never once had a problem.

good luck with what ever you end up doing.

Hey guys - dirty-cheaterer-pusseh here :(

I run a 75hp NOS brand wet nitrous system using a single fogger plumbed between the factory BOV location and the throttle body.

It works great. Boostn247, dude, just come to myhouse and have a look. Bring your notepad and a pen ;) Gimme a buzz - 0416271834

Adrian

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
×
×
  • Create New...